D-Link DIR-842 revA Router Firmware 1.02.A05 EU Download

Posted at December 21, 2024 by PCI-DB Team

D-Link DIR-842 revA Router Firmware 1.02.A05 EU Description

Enhancement:

1. Improve WPS/Reset button timing. WPS-PBC will start right after pressing 1 second, reset will be performed after 8 seconds of pressing.   
2. Improve wireless performance on Canada regulation.  
3. Improve QRS Mobile compatibility.

Problem  Resolves:

1. Clone WAN can now be set to original WAN MAC address after deleting the cloned MAC in management UI then save directly.
2. Upload configuration file to a DIR-842 will no longer change the WAN MAC address.
3. Graphical Authentication will stay enabled after performing wizard.
4. WPS-PBC will now be disabled when WEP is configured in wireless section.
5. Fix few occasion of schedule, applied to parental control will not work.

Firmware installation steps:

1. Download the latest firmware for your DIR Series router.
2. Once you've downloaded the firmware, open a web browser such as Internet Explorer or Netscape and enter the IP address of your router (192.168.0.1).
3. Enter your username (admin) and your password (leave the field blank). Click on OK to enter the web configuration for the device.
4. Click on the Tools tab and then click on Firmware on the left-hand side. Click on the Browse button and browse to the .bin file you downloaded in Step 1. Highlight the file by clicking on it once and click on Open.
5. Click on UPLOAD to upgrade firmware. It may take a up to 30 seconds for the upgrade to complete. Click on Continue when it appears. The firmware is now upgraded.

About Router Firmware:

Before you consider downloading this firmware, go to the system information page of the router and make sure that the currently installed version isn’t either newer or matching this release.

Due to the large variety of router models and different methods for upgrading the device, it is highly recommended that you read and, above all, understand the installation steps before you apply the new firmware, even if you are a power user.

In theory, these steps shouldn’t be much of a hassle for anyone, because manufacturers try to make them as easy as possible, even if they don’t always succeed. Basically, you must upload the new firmware to the router through its administration page and allow it to upgrade.

If you install a new version, you can expect increased security levels, different vulnerability issues to be resolved, improved overall performance and transfer speeds, enhanced compatibility with other devices, added support for newly developed technologies, as well as several other changes.

If you’re looking for certain safety measures, remember that it would be best if you perform the upload using an Ethernet cable rather than a wireless connection, which can be interrupted easily. Also, make sure you don’t power off the router or use its buttons during the installation, if you wish avoid any malfunctions.

If this firmware meets your current needs, get the desired version and apply it to your router unit; if not, check with our website as often as possible so that you don’t miss the update that will improve your device. 

  It is highly recommended to always use the most recent driver version available.

Try to set a system restore point before installing a device driver. This will help if you installed an incorrect or mismatched driver. Problems can arise when your hardware device is too old or not supported any longer.

Related D-Link Drivers