DIY-Thermocam Video Output Firmware 1.02 Download

Posted at April 28, 2024 by PCI-DB Team

DIY-Thermocam Video Output Firmware 1.02 Description

NOTE:

- update to devicefirmware 1.23first.

UPGRADE FIRMWARE:

1. Download and extract the firmware updater from the download section of the website.
2. Download and extract the newest firmware from the download section of the website.
3. Download, extract and install the device driver from the download section of the website.
4. Connect the DIY-Thermocam to your computer with the enclosed USB cable and turn it on. If this is the first time you connected it to your PC, wait for the driver installation to be completed.
5. The updater requires Microsoft .NET Framework 4.0 or greater.
6. Run the “Updater.exe” from the extracted archive. The updater needs internet access to update the available firmware versions.
7. Click “Open Firmware” and select the firmware version you want to flash to the device.
8. Press “Flash Firmware” and confirm the prompt with “Yes”.
9. When the DIY-Thermocam is connected to your PC and is tuned on, confirm the next prompt with “OK”. The firmware flash procedure should start automatically.
10. During the update, do not touch the USB cable or turn the device off. Once the update is complete, the DIY-Thermocam will do a reboot with the new firmware.
11. Enjoy the new features of the updated firmware.

About Camera Firmware:

Updating to a newer firmware version than the one already installed on your camera can improve the device’s overall performance and stability, resolve various issues, and add support for newly developed features or enhance existing ones.

On the other hand, downgrading the camera’s firmware can recover its functionality in the unlikely event the currently installed version is faulty or the device’s performance dropped after an upgrade. However, bear in mind that applying an earlier build might not always be possible.

It is recommended that changing the camera’s firmware be performed when the new release resolves an issue that your device has been encountering, or adds a new feature (or enhances an existing one) that could prove useful for you.

This process isn’t intended to be destructive, but still, it’s best to save all your personal data and configurations before applying a different firmware. Moreover, make sure that the battery is fully charged and don’t use the camera’s buttons while the installation is in progress.

When it comes to the update method, usually, you must copy the firmware file onto a compatible memory card, insert it into the camera, and browse from the menu to the device’s update section.

However, each device has various ways to enter the update mode and particular steps that should be taken for a successful upgrade, therefore make sure you read the product’s installation guide.

That being said, if you consider that this firmware improves your device in any way, then hit the download button and get the desired version; if not, check with our website as often as possible so that you don’t miss the update that will boost your camera’s performance. 

  It is highly recommended to always use the most recent driver version available.

Try to set a system restore point before installing a device driver. This will help if you installed an incorrect or mismatched driver. Problems can arise when your hardware device is too old or not supported any longer.

Related DIY-Thermocam Drivers