Gigabyte GA-880GM-UD2H (rev. 1.0) Realtek LAN Driver 5.792.1208.2011 for XP Download

Posted at December 3, 2024 by PCI-DB Team

Gigabyte GA-880GM-UD2H (rev. 1.0) Realtek LAN Driver 5.792.1208.2011 for XP Description

Specifications:

CPU:
- Support for AM3 processors: AMD Phenom II processor/ AMD Athlon II processor

Hyper Transport Bus:

- 5200 MT/s

Chipset:

- North Bridge: AMD 880G
- South Bridge: AMD SB710

Memory:

- 4 x 1.5V DDR3 DIMM sockets supporting up to 16 GB of system memory
- Dual channel memory architecture
- Support for DDR3 1800 (OC)/1666/1333/1066 MHz memory modules

Onboard Graphics:

- Integrated in the North Bridge
- 1 x D-Sub port
- 1 x DVI-D port
- 1 x HDMI port

Audio:

- Realtek ALC892 codec
- High Definition Audio
- 2/4/5.1/7.1-channel
- Support for Dolby Home Theater
- Support for S/PDIF In/Out
- Support for CD In

LAN:

- Realtek 8111D chip (10/100/1000 Mbit)

Expansion Slots:

- 1 x PCI Express x16 slot, running at x16 (PCIEX16)
- 1 x PCI Express x1 slot
- 2 x PCI slots

Multi-Graphics Technology:

- Support for ATI Hybrid CrossFireX technology

Storage Interface:

- 1 x IDE connector supporting ATA-133/100/66/33 and up to 2 IDE devices
- 5 x SATA 3Gb/s connectors supporting up to 5 SATA 3Gb/s devices
- 1 x eSATA 3Gb/s port on the back panel supporting up to 1 SATA 3Gb/s device
- Support for SATA RAID 0, RAID 1, RAID 10 and JBOD
- iTE IT8720 chip: 1 x floppy disk drive connector supporting up to 1 floppy disk drive

USB:

- South Bridge: Up to 12 USB 2.0/1.1 ports (6 on the back panel, 6 via the USB brackets connected to the internal USB headers)

IEEE 1394:

- T.I. TSB43AB23 chip: Up to 2 IEEE 1394a ports (1 on the back panel, 1 via the IEEE 1394a bracket connected to the internal IEEE 1394a header)

Internal I/O Connectors:

- 1 x 24-pin ATX main power connector
- 1 x 8-pin ATX 12V power connector
- 1 x floppy disk drive connector
- 1 x IDE connector
- 5 x SATA 3Gb/s connectors
- 1 x CPU fan header
- 1 x system fan header
- 1 x front panel header
- 1 x front panel audio header
- 1 x CD In connector
- 1 x S/PDIF In/Out header
- 3 x USB 2.0/1.1 headers
- 1 x IEEE 1394a header
- 1 x serial port header
- 1 x clearing CMOS jumper

Back Panel Connectors:

- 1 x PS/2 keyboard port or PS/2 mouse port
- 1 x D-Sub port
- 1 x DVI-D port
- 1 x HDMI port
- 1 x optical S/PDIF Out connector
- 1 x eSATA 3Gb/s port
- 1 x IEEE 1394a port
- 6 x USB 2.0/1.1 ports
- 1 x RJ-45 port
- 6 x audio jacks (Center/Subwoofer Speaker Out/Rear Speaker Out/Side Speaker Out/Line In/Line Out/Microphone)

I/O Controller:

- ITE IT8720 chip

H/W Monitoring:

- System voltage detection
- CPU/System temperature detection
- CPU/System fan speed detection
- CPU overheating warning
- CPU/System/Power fan fail warning
- CPU/System fan speed control

Form Factor:

- Micro ATX Form Factor: 24.4cm x 24.4cm

  It is highly recommended to always use the most recent driver version available.

Try to set a system restore point before installing a device driver. This will help if you installed an incorrect or mismatched driver. Problems can arise when your hardware device is too old or not supported any longer.

Related REALTEK Drivers