Pelco Sarix IME219 IP Camera Firmware 2.1.1.3 Download

Posted at November 2, 2024 by PCI-DB Team

Pelco Sarix IME219 IP Camera Firmware 2.1.1.3 Description

Major Fixes:

- Corrected an issue that prevented cameras from reconnecting to a Milestone VMS using ONVIF G.
- Corrected an issue that caused cameras to stop sending the primary stream, in both unicast and multicast modes.
- Corrected an issue affecting cameras connected to an SM5200 system, which caused the cameras to go offline after changing the renewal interval time.
- Improved performance of several stream configuration settings, including enabling users to adjust the aspect ratio through a Digital Sentry system.
- Enabled automatic adjustment of the bit rate to correspond to changes made to resolution.
- Corrected an issue that caused the image overlay to disappear from the Live View page if a text overlay was not also used.
- The image overlay would typically disappear after changes were made to stream configuration settings. The image and text overlays now function independently and are not affected by changes to other settings.

About Network Camera Firmware:

Updating to a newer firmware version than the one already installed on your network camera can improve the device’s overall performance and stability, resolve various issues, and add support for newly developed features or enhance existing ones.

On the other hand, downgrading the camera’s firmware can recover its functionality in the unlikely event the currently installed version is faulty, or the device’s performance dropped after an upgrade. However, bear in mind that applying an earlier build might not always be possible.

Changing the camera’s firmware must be performed when the new release resolves an issue that your device has encountered or adds a new feature (or enhances an existing one) that could prove useful to you.

As for the installation method, the steps vary depending on the model you own, but basically, you must connect your camera via an Ethernet cable (username and password required), and use the downloadable file in the Firmware Update section to upgrade your device. Make sure you do not interrupt the installation process.

However, make sure you carefully read and understand the installation steps so that you don’t end up with a broken device. This process isn’t intended to be destructive, but still, it’s best to save all configurations before applying a different firmware.

That being said, if you consider that this firmware improves your device in any way, then hit the download button and get the desired version; if not, check our website as often as possible so that you don’t miss the update that will boost your camera’s performance. 

  It is highly recommended to always use the most recent driver version available.

Try to set a system restore point before installing a device driver. This will help if you installed an incorrect or mismatched driver. Problems can arise when your hardware device is too old or not supported any longer.

Related Pelco Drivers