Lexmark C543 Printer Firmware P532/E308F Download

Posted at January 21, 2025 by PCI-DB Team

Lexmark C543 Printer Firmware P532/E308F Description

Enhancements

- Added support in the Lexmark Enterprise MIB for the following SNMP tables (for the device, inventory, and alerts OIDs): deviceTable, hwInventoryTable, supplyInventoryTable, swInventoryTable, and deviceAlertTable.
Added Out-of-Service device wipe capability.
Added SNMPv3 support.
Enhanced the history log header information.

Field Issues and Fixes

- Made changes to improve print performance for certain print jobs.
- Addressed some issues that could lead to 900.57 Firmware errors.
- Made various security improvements.
- Fixed an issue that could lead to the device stuck in the "Busy" state when printing certain PostScript jobs.
- Fixed some issues that could lead to 900 Firmware errors.
- Addressed minor memory leaks.
- Fixed an issue that could lead to an inaccurate "Coverage Last Job" value on the Device Statistics page.
- Made minor PJL improvements.
- Added Font Card Detection for NPA RDC Options command.
- Fixed some minor SNMP reporting issues.
- Fixed an issue with auto DST in conjunction with Eastern Australia time.
- Addressed an issue where the Advanced Password could be cleared on the device after it was powered down or reset.
- Addressed some issues that could lead to 976 Service Network Software errors.
- Addressed an issue that could lead to a 900.43 Firmware error.
- Fixed an issue that could lead to incorrect output on certain Postscript jobs.
- Addressed several emulator issues that led to problems printing some PDF jobs.
- Fixed an Italian translation issue on the operator panel.
- Updated UFST version from 5.0 to 5.021.
- Fixed an issue where entering the hostname in the NTP address field could fail.
- Fixed a MAC address mismatch issue between Asset Report and Network Setup Page.
- Addressed an issue that could lead to a '55 Unsupported Memory' error after replacing an operator panel.
- Fixed a problem that can occur when accessing Job History from SE menu.
- Fixed an issue that could result in scan profile not maintaining previously used values.
- Eliminated the source of some 844.02 scanner errors.
- Fixed an issue where the Driver to Fax Alternate Station Name was not replacing the Station Name in the transmission log header.
- Addressed an issue where pre-defined email messages were being truncated.
- Addressed an issue where "Log Paper Source" value in E-mail Settings was being ignored.
- Fixed an issue with setting the PDF version for scan functions.
- Addressed a problem that prevented scan-to-email in color when using address book from active directory.
- Addressed an issue where scan-to-FTP would remove spaces from path/filename.
- Added scan profile launch button support for Windows 7 and MAC.
- Added error message when Shortcut Number field is left blank while submitting a shortcut.
- Fixed an issue which could block device from receiving faxes.
- Fixed a manual fax timing issue when sending via flatbed that could lead to the receiving side timing out.
- Addressed an issue where incorrect fax number was displayed when using DBCS language.
- Addressed an issue with "Report a Fax Problem."
- Addressed a fax modem reset issue that could lead to an intermittent hang at power-up on isolated devices.

  It is highly recommended to always use the most recent driver version available.

Try to set a system restore point before installing a device driver. This will help if you installed an incorrect or mismatched driver. Problems can arise when your hardware device is too old or not supported any longer.

Related LEXMARK Drivers