Gigabyte GA-890FXA-UD5 (rev. 2.1) Realtek LAN Driver 6.250.0908.2011 for Vista Download

Posted at April 27, 2024 by PCI-DB Team

Gigabyte GA-890FXA-UD5 (rev. 2.1) Realtek LAN Driver 6.250.0908.2011 for Vista Description

Specifications:

CPU:
- Support for Socket AM3 processors: AMD Phenom II processor / AMD Athlon II processorHyper Transport Bus:

Hyper Transport Bus:

- 5200 MT/s

Chipset:

- North Bridge: AMD 890FX
- South Bridge: AMD SB850

Memory:

- 4 x 1.5V DDR3 DIMM sockets supporting up to 32 GB of system memory
- Dual channel memory architecture
- Support for DDR3 2000(OC)/1333/1066 MHz memory modules

Audio:

- Realtek ALC889 codec
- High Definition Audio
- 2/4/5.1/7.1-channel
- Support for Dolby Home Theater
- Support for S/PDIF In/Out
- Support for CD In

LAN:

- 2 x Realtek 8111D chip (10/100/1000 Mbit)
- Support for Teaming
- Support for Smart Dual LAN

Expansion Slots:

- 2 x PCI Express x16 slots, running at x16 (PCIEX16_1, PCIEX16_2)
- 1 x PCI Express x16 slots, running at x8 (PCIEX8)
- 1 x PCI Express x16 slots, running at x4 (PCIEX4)
- 2 x PCI Express x1 slot (All PCI Express slots conform to PCI Express 2.0 Standard.)
- 1 x PCI slot

Multi-Graphics Technology:

- Support for 2-way/ 3-way ATI CrossFireX technology

Storage Interface:

- 6 x SATA 6Gb/s connectors supporting up to 6 SATA 6Gb/s devices
- Support for SATA RAID 0, RAID 1, RAID5, RAID 10 and JBOD
- GIGABYTE SATA2 Chip: 1 x IDE connector supporting ATA-133/100/66/33 and up to 2 IDE devices, 2 x SATA 3Gb/s connectors supporting up to 2 SATA 3Gb/s devices
- Support for SATA RAID 0, RAID 1, and JBOD
- JMicron JMB362 chip: 2 x eSATA 3Gb/s connectors (eSATA/USB Combo) on the back panel supporting up to 2 SATA 3Gb/s devices
- Support for SATA RAID 0, RAID 1 and JBOD
- ITE 8720 chip: 1 x floppy disk drive connector supporting up to 1 floppy disk drive

USB:

- Up to 14 USB 2.0/1.1 ports (8 on the back panel, including 2 eSATA/USB Combo, 6 via the USB brackets connected to the internal USB headers)
- NEC D720200F1 Chip: Up to 2 USB 3.0/2.0 ports on the back panel

IEEE 1394:

- T.I. TSB43AB23 chip
- Up to 3 IEEE 1394a ports (2 on the back panel, 1 via the IEEE 1394a bracket connected to the internal IEEE 1394a header)

Internal I/O Connectors:

- 1 x 24-pin ATX main power connector
- 1 x 8-pin ATX 12V power connector
- 1 x floppy disk drive connector
- 1 x IDE connector
- 2 x SATA 3Gb/s connectors
- 6 x SATA 6Gb/s connectors
- 1 x CPU fan header
- 2 x system fan header
- 1 x North Bridge fan header
- 1 x power fan header
- 1 x front panel header
- 1 x front panel audio header
- 1 x CD In connector
- 1 x S/PDIF In header
- 1 x S/PDIF Out header
- 1 x IEEE 1394a header
- 3 x USB 2.0/1.1 headers
- 1 x serial port header
- 1 x parallel port header
- 1 x clearing CMOS jumper
- 1 x clearing CMOS button
- 1 x power button
- 1 x reset button

Back Panel Connectors:

- 1 x PS/2 keyboard/ mouse port
- 1 x optical S/PDIF Out connector
- 1 x coaxial S/PDIF out connector
- 2 x IEEE 1394a port
- 6 x USB 2.0/1.1 ports
- 2 x USB 3.0/2.0 ports
- 2 x eSATA/USB Combo connectors
- 2 x RJ-45 port
- 6 x audio jacks (Center/Subwoofer Speaker Out/Rear Speaker Out/Side Speaker Out/Line In/Line Out/Microphone)

I/O Controller:

- ITE IT8720 chip

H/W Monitoring:

- System voltage detection
- CPU/System temperature detection
- CPU/System fan speed detection
- CPU overheating warning
- CPU/System fan fail warning
- CPU/System fan speed control

Form Factor:

- ATX Form Factor: 30.5cm x 24.4cm

  It is highly recommended to always use the most recent driver version available.

Try to set a system restore point before installing a device driver. This will help if you installed an incorrect or mismatched driver. Problems can arise when your hardware device is too old or not supported any longer.

Related REALTEK Drivers