Panasonic DMW-YAGH Interface Unit Firmware 1.1 Download

Posted at December 21, 2024 by PCI-DB Team

Panasonic DMW-YAGH Interface Unit Firmware 1.1 Description

Important Note:

- Following functions are available to support the upgrade of Panasonic DMC-GH4 Camera Firmware 2.1.

Time code:

- Time code can be embedded to the HDMI output signal
- Selectable in Motion Picture menu: [Time Code] > [HDMI Time Code Output]
- Available when DMC-GH4 or DMW-YAGH are connected with products of ATOMOS Global Pty. Ltd. or products complying with the extended specifications of ATOMOS Global Pty. Ltd..

RSS (Recording Start/Stop):

- RSS (Recording Start/Stop) signal can be embedded to the HDMI output signal
- Selectable in Motion Picture menu: [HDMI Rec Output] > [HDMI Recording Control]
- Available when DMC-GH4 or DMW-YAGH are connected with products of ATOMOS Global Pty. Ltd. or products complying with the extended specifications of ATOMOS Global Pty. Ltd..

Other Changes:

- FHD at 30p/25p native output via HDMI is available while recording video in FHD at 30p/25p.
- FHD at 30PsF / 25PsF output via SDI is available while recording video in FHD at 30p/25p

  It is highly recommended to always use the most recent driver version available.

Try to set a system restore point before installing a device driver. This will help if you installed an incorrect or mismatched driver. Problems can arise when your hardware device is too old or not supported any longer.

Related Panasonic Drivers