Intel ir3 3108 ROC Hardware RAID Firmware 24.6.0-0030 Download

Posted at November 21, 2024 by PCI-DB Team

Intel ir3 3108 ROC Hardware RAID Firmware 24.6.0-0030 Description

Firmware 4.260.00-3882

- (Closed) - 3008 iMR - DPA extended capabilities bits structure is invalid
- (Closed) - Firmware logs are not dumped to flash during device discovery phase
- (Port_Not_Required) - Failed LED on 10HD BP does not light correctly for a bad drive
- (Port_Complete) - Firmware indicating that PD can be spun down even in online state
- (Port_Complete) - GPIO 24-31 is should be low when activity is going on drive
- (Port_Complete) - Behavior change when FW hit fault code 0x81 (uncorrectable ECC error)
- (Port_Complete) - Identify FDE drive compliant to Opal spec and mark them as non-FDE drive
- (Port_Complete) - Workaround for Hardware Issue - SCGCQ00632364
- (Port_Complete) - Virtual Disk GUID field changes when a VD is moved. The LUID is supposed to be unique and invariant.
- (Port_Complete) - The field "expanderFwVersion=" is not populated under "ctrl info" in megamon
- (Port_Complete) - Need MR 6.3 iMR Firmware Capable of Updating the SBR on a Customer Board in the Field
- (Port_Complete) - Expander reports wrong active firmware version
- (Port_Complete) - If diagnostic test fails on the copyback drive the FW does not allow a Recon, Copyback and CC on the same VD.
- (Port_Complete) - OEM Expander (Truchas Valley) reporting temperature sensor error

NVDATA 3.1408.00-0007

- (Port_Complete) - Customer needs NVDATA changes for PHY-to-SLOT mapping
- Various other changes for specific OEMs.

UEFI_Driver 0x06090701 (SIGNED)

- (Closed) - Direction bit is not set for READ CAPACITY commands

Hii v03.10.09.01(SIGNED)

- (Closed) - The last digit for Expander FW version is truncated

BIOS 6.20.04.1

- (Closed) - Don't issue REAID I/O on the 4K JBOD

Other versions:

- ROMENV 1.09
- BootBlock 3.02.00.00-0001
- Ctrl-R 5.07-0006
- PCLI 1.07.05
- FCODE 4.16.08.00

This download is valid for the products listed below.

- Intel Integrated RAID Module RMS3CC040
- Intel Integrated RAID Module RMS3CC080
- Intel RAID Controller RS3DC040
- Intel RAID Controller RS3DC080
- Intel RAID Controller RS3MC044
- Intel RAID Controller RS3SC008

  It is highly recommended to always use the most recent driver version available.

Try to set a system restore point before installing a device driver. This will help if you installed an incorrect or mismatched driver. Problems can arise when your hardware device is too old or not supported any longer.

Related Intel Drivers