D-Link DCS-1100 Camera Firmware 1.0.3 Download

Posted at December 22, 2024 by PCI-DB Team

D-Link DCS-1100 Camera Firmware 1.0.3 Description

How to update your camera firmware:

- Check your connections. Make sure your device is connected to your router with an Ethernet cable for the upgrade process. Do not use a wireless connection when upgrading the firmware.
- Also, make sure you use a computer connected to the same router as your device. Do not perform this process through a remote connection to your device over the Internet.
- Download the firmware to your PC and then unzip it if necessary.
- Open your device’s web interface. To do this run your device’s Setup Wizard and write down the IP Address for your device then write that IP Address into your web browser and login as admin with your password for it.
- Go to MAINTENANCE > Firmware Upgrade to go to the Firmware Upgrade page. Click “Browse” and then select the firmware file you saved and unzipped on your computer in the previous steps.
- After selecting the firmware file, click Upload to start the upgrade process.
- The upgrade process will begin, and will take about 2-3 minutes to complete. Do not start or use other applications while upgrading your device’s firmware, and do not hit Stop, Back, or Reload in your web browser during the upgrade process.
- Once the upgrade process is complete, click on the Firmware Upgrade link on the left to return to the Firmware Upgrade page.
- Verify that the Current Firmware Version matches the version of the firmware you uploaded. The upgrade process is complete, and you can close your web browser.

  It is highly recommended to always use the most recent driver version available.

Try to set a system restore point before installing a device driver. This will help if you installed an incorrect or mismatched driver. Problems can arise when your hardware device is too old or not supported any longer.

Related D-Link Drivers