Gigabyte GA-990FXA-UD3 (rev. 1.0) Etron USB 3.0 Driver 1.0.0.118 Download

Posted at November 5, 2024 by PCI-DB Team

Gigabyte GA-990FXA-UD3 (rev. 1.0) Etron USB 3.0 Driver 1.0.0.118 Description

Specifications:

CPU:
- AM3+ Socket:
- Support for AMD AM3+ FX processors
- Support for AMD AM3 Phenom II processors / AMD Athlon II processors

Hyper Transport Bus:

- 5200 MT/s

Chipset:

- North Bridge: AMD 990FX
- South Bridge: AMD SB950

Memory:

- 4 x 1.5V DDR3 DIMM sockets supporting up to 32 GB of system memory
- Dual channel memory architecture
- Support for DDR3 2000(O.C.)/1866/1600/1333/1066 MHz memory modules

Audio:

- Realtek ALC889 codec
- High Definition Audio
- 2/4/5.1/7.1-channel
- Support for Dolby Home Theater
- Support for S/PDIF Out

LAN:

- 1 x Realtek RTL8111E chip (10/100/1000 Mbit)

Expansion Slots:

- 2 x PCI Express x16 slots, running at x16 (PCIEX16_1, PCIEX16_2)
- 2 x PCI Express x16 slots, running at x4 (PCIEX4_1, PCIEX4_2)
- 2 x PCI Express x1 slots
- 1 x PCI slot

Multi-Graphics Technology:

- Support for 2-Way AMD CrossFireX and NVIDIA SLI technology (PCIEX16_1, PCIEX16_2)

Storage Interface:

- 6 x SATA 6Gb/s connectors (SATA3_0~SATA3_5) supporting up to 6 SATA 6Gb/s devices
- Support for SATA RAID 0, RAID 1, RAID5, RAID 10 and JBOD
- 2 x Marvell 88SE9172 chips: 2 x eSATA 6Gb/s connectors on the back panel supporting up to 2 SATA 6Gb/s devices
- Support for RAID 0 and RAID 1

USB:

- Up to 14 USB 2.0/1.1 ports (8 ports on the back panel, 6 ports available through the internal USB headers)
- 2 x Etron EJ168 chips: Up to 4 USB 3.0/2.0 ports (2 ports on the back panel, 2 ports available through the internal USB header)

IEEE 1394:

- VIA VT6308 chip
- Up to 2 IEEE 1394a ports (1 port on the back panel, 1 port available through the internal IEEE 1394a header)

Internal I/O Connectors:

- 1 x 24-pin ATX main power connector
- 1 x 8-pin ATX 12V power connector
- 6 x SATA 6Gb/s connectors
- 1 x CPU fan header
- 2 x system fan headers
- 1 x power fan header
- 1 x front panel header
- 1 x front panel audio header
- 1 x S/PDIF Out header
- 3 x USB 2.0/1.1 headers
- 1 x USB 3.0/2.0 header
- 1 x IEEE 1394a header
- 1 x Trusted Platform Module (TPM) header
- 1 x serial port header
- 1 x clearing CMOS jumper

Back Panel Connectors:

- 1 x PS/2 keyboard/mouse port
- 1 x optical S/PDIF Out connector
- 1 x IEEE 1394 port
- 8 x USB 2.0/1.1 ports
- 2 x USB 3.0/2.0 ports
- 2 x eSATA 6Gb/s connector
- 1 x RJ-45 port
- 6 x audio jacks (Center/Subwoofer Speaker Out/Rear Speaker Out/Side Speaker Out/Line In/Line Out/Microphone)

I/O Controller:

- ITE IT8720 chip

H/W Monitoring:

- System voltage detection
- CPU/System temperature detection
- CPU/System/Power fan speed detection
- CPU overheating warning
- CPU/System/Power fan fail warning
- CPU/System fan speed control

Form Factor:

- ATX Form Factor: 30.5cm x 24.4c

  It is highly recommended to always use the most recent driver version available.

Try to set a system restore point before installing a device driver. This will help if you installed an incorrect or mismatched driver. Problems can arise when your hardware device is too old or not supported any longer.

Related Etron Drivers