INSYS MoRoS 2.0 & 2.1 / MLR 2.0 Firmware 2.11.0 Download

Posted at December 22, 2024 by PCI-DB Team

INSYS MoRoS 2.0 & 2.1 / MLR 2.0 Firmware 2.11.0 Description

Intended use for INSYS products:

- All MoRoS 2.0 devices
- All MoRoS 2.1 devices
- All MLR 2.0 devices

Important notes:

- If your device has a previous firmware version of at least 1.x.x this update cannot be used!
- If your device has a previous firmware version of at least 2.0.0 but before 2.2.0, an intermediate update step to 2.2.1 must be performed before. This update is available from the INSYS support department.

Preconditions:

- Make sure nobody else is working on the web interface too!
- The power supply must not fail or be switched off in any case!
- We recommend to save the configuration first

New Features:

IT-Security:
- MAC-Filter
- New Messages (SMS,e-mail, SNMP trap) for: false authentication at the web interface, change of the link status (up, down) at the Ethernet ports, configuration change, and firewall violations from LAN and/or WAN
- SNMP messages with sender identification (host name, location)
- Web interface: Concealment of passwords (web authentication, DynDNS, PIN)
- Web interface: all configuration accesses can be disabled (http/https local and remote)
- DNS relay can be disabled

Dial-Out connection:

- Re-establishment also for PING monitoring
- New option: change of the target for each new dial-in
- PPP packet size configurable (MTU, MRU)
- New SMS commands "dial start" and "dial stop"
- For permanent connection: restart of the cellular engine in case of unsuccessful connection establishment after 30 minutes

VPN:

- GRE tunnel
- OpenVPN client via proxy (TCP)

Addressing:

- IP forwarding: realization of virtual LAN (ext) addresses on internal local devices at the router
- DHCP client requests virtual (LAN (ext)) IP addresses for each host table entry with the name "HostNameRouter_HostNameEntry"
- DHCP server: Alternative IP addresses for default gateway and DNS server can be assigned to the DHCP clients.

Operation:

- Graphical indication of the signal strength for cellular devices
- Manual updates: file name, type and checksum are stored in system message
- ASCII configuration file can be exported to the sandbox

Miscellaneous:

- NTP server: the router can serve as time server for local terminal devices

Bug Fixes:

- Fall-back to existing IP address in case an incomplete address has been entered
- Local netmask for networks with 192.168.x.x, 172.16.x.x and 10.x.x.x remains maintained after firmware update
- Time zone difference sign (+/-) will be written correctly in the logs for GMT time zones as well

  It is highly recommended to always use the most recent driver version available.

Try to set a system restore point before installing a device driver. This will help if you installed an incorrect or mismatched driver. Problems can arise when your hardware device is too old or not supported any longer.

Related Others Drivers