Creative Sound Blaster X-Fi Titanium Fatal1ty Champion Series Driver 2.17.0008C Beta for Windows 8 Download

Posted at April 27, 2024 by PCI-DB Team

Creative Sound Blaster X-Fi Titanium Fatal1ty Champion Series Driver 2.17.0008C Beta for Windows 8 Description

Technical Specs:

- 24-bit Analog-to-Digital conversion of analog inputs: 96kHz sample rate
- 24-bit Digital-to-Analog conversion of digital sources: 96kHz to analog 7.1 speaker output
- 24-bit Digital-to-Analog conversion of stereo digital sources: 192kHz to stereo output
- 16-bit to 24-bit recording sampling rates: 8,11.025,16, 22.05, 24, 32, 44.1, 48 and 96kHz
- ASIO 2.0 support: 16bit/44.1kHz,16-bit/48kHz, 24-bit/44.1kHz 24-bit/48kHz and 24-bit/96kHz with direct monitoring
- Enhanced SoundFont support: Up to 24-bit resolution
- X-RAM: 64MB

Audio Performance (Rated Output @ 2Vrms, Typical Value):

- Signal-to-Noise Ratio (20kHz Low-pass filter, A-Weighted): Stereo Output 109dB, Front and Rear Channels 109dB, Center, Subwoofer and Side Channels 109dB
- Total Harmonic Distortion + Noise at 1kHz (20kHz Low-pass filter): 0.004%
- Frequency Response (-3dB, 24-bit/96kHz input ): 10Hz to 46kHz
- Frequency Response (-3dB, 24-bit/192kHz input): 10Hz to 88kHz (Stereo only)

Connectivity:

- Line in / Microphone In: Shared 1/8" mini jack
- Speaker Out: 4x 1/8" mini jacks
- Optical Out: TOSLINK 1
- Optical In: TOSLINK
- Intel HD Audio Compatible Front Panel Header: 2x 5-pin
- Creative proprietary AND_EXT connector: Connects to one end of the AND_EXT cable. Connect the other end to the AND_EXT connector on the Sound Blaster X-Fi I/O Drive.
- Creative proprietary DID_EXT connector: Connects to one end of the DID_EXT cable. Connect the other end to the DID_EXT connector on the Sound Blaster X-Fi I/O Drive.

I/O Drive Connectivity:

- Auxiliary input: Two RCA jacks
- Headphone output and volume control: 3. 50 mm (1/8-inch) stereo jack
- Microphone input: 3. 50 mm (1/8-inch) stereo jack

  It is highly recommended to always use the most recent driver version available.

Try to set a system restore point before installing a device driver. This will help if you installed an incorrect or mismatched driver. Problems can arise when your hardware device is too old or not supported any longer.

Related CREATIVE Drivers