Buffalo TS5800D NAS Firmware 2.80 for Mac OS Download

Posted at December 3, 2024 by PCI-DB Team

Buffalo TS5800D NAS Firmware 2.80 for Mac OS Description

System Changes:

- Fixed a bug where the system hanged up when the high load affected to the TeraStation.

Replication Changes:

- Fixed a bug where the performance of TeraStation became slow when too many files were copied to the replication target.

Drives Changes:

- Fixed a bug where the E22 error message remained even after the defective drive was replaced with a new drive and the RAID array was rebuilt.
- Fixed a bug where the E30 error message disappeared when restarting the TeraStation while a failed drive was connected and the RAID array was in degraded mode.

Before updating the firmware:

- Do not turn off the TeraStation until the firmware update is complete and the "finished" message is displayed.
- USB drives may not be mounted automatically after updating the firmware. To mount them, unplug and then reconnect them.
- Disconnect iSCSI volumes with the iSCSI Initiator before updating the firmware.

How to update your firmware:

- Extract the file you have downloaded.
- Please execute "update", refer to the screen instruction.

  It is highly recommended to always use the most recent driver version available.

Try to set a system restore point before installing a device driver. This will help if you installed an incorrect or mismatched driver. Problems can arise when your hardware device is too old or not supported any longer.

Related Buffalo Drivers