D-Link DAP-2690 rev.A1 Wireless Access Point Firmware 1.11rc040 Download

Posted at May 5, 2024 by PCI-DB Team

Install Driver Automatically

Device Name	D-Link DAP-2690 rev.A1 Wireless Access Point Firmware 1.11rc040
Category	Firmware
Manufacturer	D-Link
File Size	6.8 MB
Supported OS	Windows All

D-Link DAP-2690 rev.A1 Wireless Access Point Firmware 1.11rc040 Description

Fixes:
- Fixed Wireless stop service when too much interference in user environment.
- Fixed ARP table overflow issue.
- WDS x 2 has Low throughput
- Fixed when enable the limit administrator vlan id but the web redirection doesn't disable
- Fixed downlink interface can't save success in traffic control
- Fixed when IGMP Snooping enable it don't block 224.0.0.252 in Multicast Bandwidth Control & IGMP Snooping
- Add & Modify the commands of Multicast Bandwidth control.
- Fixed the AP hang up when running pressure test in Web Redirect. ( about 120~150 web sessions)
- Fixed Web authentication fail
- Fixed Web redirect + Web authentication fail
- Fixed LLTD packet will let br0 enter promiscuous mode, and cause memory leak.
- Fixed in 5G band, when set the WPA/WPA2-auto-Enterprise-TKIP,the channel width should be 20MHz and gray
- Fixed when delete the Static IP Pool, but the STA will always get the same static IP.
- Fixed when set the wireless mode is the mixed 802.11g and 802.11b, the channel width should be the gray to 20MHz at all times.
- When set 802.11n only, the security-TKIP and WEP UI should be gray or would not have this item.
- When build the APC mode, the signal is show error.
- Fixed in Time and Date Settings some TimeZone can't get the correct time.
- Fixed when enable the Multi SSID and modify it, the page will show error.
- Fixed when the HEX encrypt, set a~f, it will match upper/lower case. but when connect AP use STA, it will not match upper/lower case
- Fixed in 11a band/WPA-PSK/Periodical Key Change :it can't show time interval in email log info
- Fixed in 5Ghz Multi-SSID+Periodical Key Change when save and active, PassPhrase show null.
- Fixed 20 clients connect with AP, endurance test fail.

  It is highly recommended to always use the most recent driver version available.

Try to set a system restore point before installing a device driver. This will help if you installed an incorrect or mismatched driver. Problems can arise when your hardware device is too old or not supported any longer.

Related D-Link Drivers