Kingston SE100S3 SSD Firmware Rev.507KC4 for Linux Download

Posted at April 30, 2024 by PCI-DB Team

Kingston SE100S3 SSD Firmware Rev.507KC4 for Linux Description

Intended for:

- SE100S37/100G
- SE100S37/200G
- SE100S37/400G
- SE100S37/100GBK
- SE100S37/200GBK
- SE100S37/400GBK

Fixes:

- Enables TRIM support
- Improved TRIM operation during SATA error handling
- Improved handling of internal command errors
- Improved the efficiency of flash error recovery
- Fixed an issue where S.M.A.R.T. Attribute 194 would not report “128” if the temperature sensor on the I2C times out

  It is highly recommended to always use the most recent driver version available.

Try to set a system restore point before installing a device driver. This will help if you installed an incorrect or mismatched driver. Problems can arise when your hardware device is too old or not supported any longer.

Related Kingston Drivers