Rosewill RNX-N1 Wireless USB Adapter Ralink WLAN Driver 3.2.11.0 Download

Posted at December 22, 2024 by PCI-DB Team

Install Driver Automatically

Device Name	Rosewill RNX-N1 Wireless USB Adapter Ralink WLAN Driver 3.2.11.0
Category	Network Card
Manufacturer	Ralink
File Size	31.9 MB
Supported OS	Windows 2K ,Windows XP ,Windows Vista ,Windows XP 64 bit ,Windows Vista 64 bit ,Windows 7 ,Windows 7 64 bit ,Windows 8 ,Windows 8 64 bit

Rosewill RNX-N1 Wireless USB Adapter Ralink WLAN Driver 3.2.11.0 Description

Features:
- The easiest way to upgrade your system into wireless N network.
- Connect your PC/NB to a wireless network in minutes using high speed USB2.0 interface.
- 12x speed and 4x coverage over wireless G.
- 802.11b/g/n 2.0 provide further coverage, less dead spot and higher throughput.
- MIMO technology up to 300 Mbps for Ralink 2T2R solution.
- Supports MIMO technology with 2 Built-in Internal Printed Antennas
- Easy setup with Wi-Fi Protected Setup (WPS).
- Security support WPA/WPA2 (AES, 64,128-WEP with shared-key authentication).
- Support Cisco CCS V1.0, V2.0 and V3.0 compliant WPS.
- Wireless Multimedia Enhancements Quality of Service support (QoS) / enhanced power saving for Dynamic Networking
- RNX-N1 is also fully compatible with IEEE 802.11b/g standard.
- Compatible with Windows 2000, XP (32/64 bit), Vista (32/64 bit), Win7 (32/64 bit) ; Mac 10.3/ 10.4/ 10.5/ 10.6
- LED indicator for Power/Link
- Advanced power management for Low power consumption

Installation steps (for exe / zip):

1. Save the driver files to your computer.
2. Run the executable or extract the installation files to a location on your disk.
3. Follow the steps displayed by the setup wizard.
4. After installation, restart the computer.

Important notes:

- Before installation, save all your work and close all the running programs, as the installation may interfere with other apps;
- If the setup wizard requests Administrative rights, make sure to run the setup as Administrator;
- Pay attention to all installation instructions to make sure the driver is installed correctly;

About USB Network Adapter Driver:

When connected, the operating system usually installs a generic driver that helps the computer to recognize the newly attached device.

However, proper software must be applied if you want to make use of all features that the network adapter has available. This task also allows computers to properly recognize all device characteristics such as manufacturer, chipset, technology, and others.

Updating the adapter’s drivers and utilities version might improve overall performance and stability, increase transfer speeds, fix different compatibility problems and several network-related errors, as well as bring various other changes.

To install this release, simply get the package, extract it if necessary, run the setup, and follow the instructions displayed on-screen. When done, don’t forget to perform a system restart and reconnect the network adapter to make sure that all changes take effect properly.

Without further ado, if you intend to apply this version, click the download button and install the package. Moreover, check with our website as often as possible so that you don’t miss a single new release.

  It is highly recommended to always use the most recent driver version available.

Try to set a system restore point before installing a device driver. This will help if you installed an incorrect or mismatched driver. Problems can arise when your hardware device is too old or not supported any longer.

Related Ralink Drivers