INSYS IMON-U310 Fault Monitor Firmware 2.12.8 Download

Posted at November 5, 2024 by PCI-DB Team

INSYS IMON-U310 Fault Monitor Firmware 2.12.8 Description

Functional Enhancements:

- Web interface: New host name (appstart) for direct access to the Monitoring App (default: appstart.local)
- Web interface: Microsoft Edge browser support
- Firewall: Selective release of UDP port 4500 for NAT traversal in modes “activate” or “force”

Further Improvements:

- MoRoS Modem: Stability for Dial-In and Dial-Out connections with access to LAN devices-optimised
- Redundant WAN: Changeover optimised and link loss detection for LAN(ext) now also with device start
- EBW-L: VPN connection establishment with device restart optimised
- Messages: Detection of link loss and link up at LAN(ext) corrected (applies to MoRoS only)
- Sandbox: optimised memory handling for MoRoS and IMON
- Inputs: Pulse detection for MoRoS optimised
- MoRoS: accelerated initialisation of switch and external modem (RS232 port) with device restart
- ASCII configuration: Parameters “username” and “password” for OpenVPN client without “CR/LF” with download
- ASCII configuration: Parameter “direction” amended for WWAN firewall rules (applies to EBW-L100 only)
- ASCII configuration: Parameter “apply” for port forwarding rules effective for all entries

Important notes:

- If your device has a previous firmware version of at least 1.x.x this update cannot be used!
- If your device has a previous firmware version of at least 2.0.0 but before 2.3.0, an intermediate update step to 2.2.1, and then an intermediate update step to 2.6.2 must be performed before.
- If your device has a previous firmware version of at least 2.3.0 but before 2.6.0, an intermediate update step to 2.6.2 must be performed before.

Preconditions:

- Make sure nobody else is working on the web interface too!
- The power supply must not fail or be switched off in any case!
- We recommend to save the configuration first.

About Router Firmware:

Before you consider downloading this firmware, go to the system information page of the router and make sure that the currently installed version isn’t either newer or matching this release.

Due to the large variety of router models and different methods for upgrading the device, it is highly recommended that you read and, above all, understand the installation steps before you apply the new firmware, even if you are a power user.

In theory, these steps shouldn’t be much of a hassle for anyone, because manufacturers try to make them as easy as possible, even if they don’t always succeed. Basically, you must upload the new firmware to the router through its administration page and allow it to upgrade.

If you install a new version, you can expect increased security levels, different vulnerability issues to be resolved, improved overall performance and transfer speeds, enhanced compatibility with other devices, added support for newly developed technologies, as well as several other changes.

If you’re looking for certain safety measures, remember that it would be best if you perform the upload using an Ethernet cable rather than a wireless connection, which can be interrupted easily. Also, make sure you don’t power off the router or use its buttons during the installation, if you wish avoid any malfunctions.

If this firmware meets your current needs, get the desired version and apply it to your router unit; if not, check with our website as often as possible so that you don’t miss the update that will improve your device. 

  It is highly recommended to always use the most recent driver version available.

Try to set a system restore point before installing a device driver. This will help if you installed an incorrect or mismatched driver. Problems can arise when your hardware device is too old or not supported any longer.

Related INSYS Drivers