Soloshot Pentax K20D Camera Controller Firmware 061015 Download

Posted at November 5, 2024 by PCI-DB Team

Soloshot Pentax K20D Camera Controller Firmware 061015 Description

NOTE:

- for Pentax K20D Camera

Installation Steps:

Step 1 | Jumpdrive 2.0
You need a USB 2.0 Jumpdrive to update firmware. Make sure USB:
- Has NO files on it.
- Jump drive must be formatted to FAT or FAT32.

Step 2 | Zip File
Download the zip file containing firmware

Step 3 | Unzip
Locate downloaded file and unzip to reveal firmware folder

Step 4 | Copy Files
Open folder and copy files from the firmware folder DIRECTLY to the USB 2.0 Jumpdrive.
Important: Do not copy the folder onto your Jumpdrive.

Step 5 | Dock Controller
While holding down the update button on top of Camera Controller, dock into Accessory Port on Base at 45-degree angle.
Push the controller flush to the Base until it clicks into place.

Step 5 | Controller Updates
Camera Controller LED will flash RED/GREEN during update.
LED 6 on Base will flash RED/GREEN as Controller updates.

Step 7 | Controller Updated
Camera Controller LED will turn RED when update complete.
On the Base:
- LED 1 will be blinking.
- LED 2 and 3 will be solid.

Step 8 | Release Controller
Slide the dock button down to release Camera Controller.
Remove jumpdrive from side of Base.

About Digital Camera Firmware:

Updating to a newer firmware version than the one already installed on your camera can improve the device’s overall performance and stability, resolve various issues, and add support for newly developed features or enhance existing ones.

On the other hand, downgrading the camera’s firmware can recover its functionality in the unlikely event the currently installed version is faulty or the device’s performance dropped after an upgrade. However, bear in mind that applying an earlier build might not always be possible.

It is recommended that changing the camera’s firmware be performed when the new release resolves an issue that your device has been encountering, or adds a new feature (or enhances an existing one) that could prove useful for you.

This process isn’t intended to be destructive, but still, it’s best to save all your personal data and configurations before applying a different firmware. Moreover, make sure that the battery is fully charged and don’t use the camera’s buttons while the installation is in progress.

When it comes to the update method, usually, you must copy the firmware file onto a compatible memory card, insert it into the camera, and browse from the menu to the device’s update section.

However, each device has various ways to enter the update mode and particular steps that should be taken for a successful upgrade, therefore make sure you read the product’s installation guide.

That being said, if you consider that this firmware improves your device in any way, then hit the download button and get the desired version; if not, check with our website as often as possible so that you don’t miss the update that will boost your camera’s performance.

  It is highly recommended to always use the most recent driver version available.

Try to set a system restore point before installing a device driver. This will help if you installed an incorrect or mismatched driver. Problems can arise when your hardware device is too old or not supported any longer.

Related Soloshot Drivers