Posted at December 24, 2024 by PCI-DB Team
Install Driver AutomaticallyDevice Name | EVGA GeForce GTX 680 Classified EVBot GPU Flash Tool 1.0.0.2 |
---|---|
Category | Other Drivers Tools |
Manufacturer | EVGA |
File Size | 206 KB |
Supported OS | Windows All |
- Initial release
- EVGA GeForce GTX 680 Classified
- EVGA GeForce GTX 580 Classified
- EVGA GeForce GTX 285 Classified
- Connect the EVBot cable to the MB port located on the EVBot device.
- Connect the other end of the EVBot cable to your graphics card.
- Run EVBotFlashTool.exe
- Select the bundled .hex file for flashing.
- Hold down the EVBot POWER button for 7 seconds until you see the EVBot screen display FLASH MODE.
- Click OK in EVBot Flash Tool to being the flashing process.
- After flash is complete, unplug EVBot, then plug it back in to any EVBot port.
It is highly recommended to always use the most recent driver version available.
Try to set a system restore point before installing a device driver. This will help if you installed an incorrect or mismatched driver. Problems can arise when your hardware device is too old or not supported any longer.
Device Type: Graphics Board File Size: 1.7 MB OS Independent
Install DriverDevice Type: Graphics Board File Size: 1.9 MB OS Independent
Install DriverDevice Type: Graphics Board File Size: 1.9 MB OS Independent
Install DriverDevice Type: Firmware File Size: 1.7 MB OS Independent
Install DriverDevice Type: Graphics Board File Size: 1.6 MB OS Independent
Install DriverDevice Type: Graphics Board File Size: 848 KB OS Independent
Install DriverDevice Type: Firmware File Size: 581 KB OS Independent
Install DriverDevice Type: Graphics Board File Size: 542 KB OS Independent
Install DriverFind Missing Drivers
Recent Devices
Recent Drivers
© 2024 PCI-DB.com - PCI Database Replacement. All rights reserved.