Bushnell Trophy Cam HD Aggressor 119774 Camera Firmware BS685BWYx08234 Download

Posted at November 21, 2024 by PCI-DB Team

Install Driver Automatically

Device Name	Bushnell Trophy Cam HD Aggressor 119774 Camera Firmware BS685BWYx08234
Category	Scanner Digital Camera Webcam
Manufacturer	Bushnell
File Size	5.9 MB
Supported OS	OS Independent

Bushnell Trophy Cam HD Aggressor 119774 Camera Firmware BS685BWYx08234 Description

This package provides the necessary installation files of Bushnell Trophy Cam HD Aggressor 119774 Camera Firmware BS685BWYx08234. This firmware applies only for the cameras with current firmware version number ending in 228 or 22F.

Installation steps:

1. Download the firmware files.
2. Click on the appropriate firmware version to begin downloading the .zip file.
3. Open the .zip file.
4. Drag both files (.elf and spec.bin) to your desktop. Or you can right click the downloaded .zip file and select “extract all” .
5. Insert SD card into computer / SD card reader and open, you should either see a blank screen, or one folder labeled “DCIM.”
a. If any file exist on the SD Card it is best to format the card.
6. Copy .elf and spec.bin files onto SD card. (DO NOT place into DCIM folder).
7. Remove SD card from computer once the files have been copied.
8. Insert SD card into your Trophy Cam, along with a new set of 8 – AA Batteries.
9. Press and hold the Up Arrow button. (Far left button).
10. While holding the Up Arrow, slide the power switch to “setup.”
11. A Green LED (on the front of the camera) will begin flashing and you can release the Up Arrow. (The Green LED is located in the same location as the RED PIR indicating LED, which will flash as well when motion is detected.)
12. When Green LED stops flashing, the update is complete.
13. Power OFF your Trophy Cam when the update is complete.
14. To double check Firmware version, slide the power switch to “SETUP.” Press the “MENU” button and then press the “LEFT” arrow key. Firmware version will be displayed.

About Camera Firmware:

Updating to a newer firmware version than the one already installed on your camera can improve the device’s overall performance and stability, resolve various issues, and add support for newly developed features or enhance existing ones.

On the other hand, downgrading the camera’s firmware can recover its functionality in the unlikely event the currently installed version is faulty or the device’s performance dropped after an upgrade. However, bear in mind that applying an earlier build might not always be possible.

It is recommended that changing the camera’s firmware be performed when the new release resolves an issue that your device has been encountering, or adds a new feature (or enhances an existing one) that could prove useful for you.

This process isn’t intended to be destructive, but still, it’s best to save all your personal data and configurations before applying a different firmware. Moreover, make sure that the battery is fully charged and don’t use the camera’s buttons while the installation is in progress.

When it comes to the update method, usually, you must copy the firmware file onto a compatible memory card, insert it into the camera, and browse from the menu to the device’s update section.

However, each device has various ways to enter the update mode and particular steps that should be taken for a successful upgrade, therefore make sure you read the product’s installation guide.

That being said, if you consider that this firmware improves your device in any way, then hit the download button and get the desired version; if not, check with our website as often as possible so that you don’t miss the update that will boost your camera’s performance. 

  It is highly recommended to always use the most recent driver version available.

Try to set a system restore point before installing a device driver. This will help if you installed an incorrect or mismatched driver. Problems can arise when your hardware device is too old or not supported any longer.

Related Bushnell Drivers