Mellanox MHGA28-XT HCA Card Firmware 5.3.000 Download

Posted at November 21, 2024 by PCI-DB Team

Mellanox MHGA28-XT HCA Card Firmware 5.3.000 Description

New Features:

- Active cable support

Added the following debug features:

- The new .ini parameter absorb_ecc_unrecoverable can be used to configure the HCA to treat DIMM unrecoverable errors as recoverable
- The new .ini parameter gpio_num_indicates_fsr_en can be used to set a specific GPIO to indicate whether Fast Self-Refresh mode is enabled or disabled. See the command ENABLE_LAM in the PRM.

Bug Fixes:

- Doorbell loss upon UAR page size >= 64KB
- A false Fatal Error is reported upon a WQE fetch translation error
- May cause an internal error upon closing QPs in a condition of RNR stress
- Performance may be degraded upon receiving a multicast packet that is not a member of any multicast group
- MTT corruption
- Under very stressful conditions, multiple receive CQEs may be generated
- It is possible to re-enable a port using a MAD after disabling it with the command ModStatConfig
- NodeInfo returns the wrong Revision (device revision) value for a DDR device
- A Send CQE with error is generated only if the QP was in RTS prior to moving to the Error state
- The command QUERY_FW fails after running the RUN_FW command
- The HCA might exceed the maximum trap generation rate upon processing different trap types
- Suspend_QP command timeout

  It is highly recommended to always use the most recent driver version available.

Try to set a system restore point before installing a device driver. This will help if you installed an incorrect or mismatched driver. Problems can arise when your hardware device is too old or not supported any longer.

Related Mellanox Drivers