Gigabyte GA-MA770-DS3 (rev. 1.0) Realtek LAN Driver 5.792.1208.2011 for XP Download

Posted at November 21, 2024 by PCI-DB Team

Gigabyte GA-MA770-DS3 (rev. 1.0) Realtek LAN Driver 5.792.1208.2011 for XP Description

Specifications:

CPU:
- Support for Socket AM2+ / AM2 processors: AMD Phenom FX processor/ AMD Phenom processor/ AMD Athlon 64 FX processor/AMD Athlon 64 X2 Dual-Core processor/AMD Athlon 64 processor/AMD Sempron processor

Hyper Transport Bus:

- 5200/2000 MT/s

Chipset:

- North Bridge: AMD 770
- South Bridge: AMD SB600

Memory:

- 4 x 1.8V DDR2 DIMM sockets supporting up to 16 GB of system memory
- Dual channel memory architecture
- Support for DDR2 1066/800/667 MHz memory modules
- Support ECC memory

Audio:

- Realtek ALC888 codec
- High Definition Audio
- 2/4/5.1/7.1-channel
- Support for S/PDIF In/Out
- Support for CD In

LAN:

- Realtek 8111B chip (10/100/1000 Mbit)

Expansion Slots:

- 1 x PCI Express x16 slot (The PCI Express x16 slot conforms to PCI Express 2.0 standard.)
- 4 x PCI Express x1 slots
- 2 x PCI slots

Storage Interface:

- 1 x IDE connector supporting ATA-133/100/66/33 and up to 2 IDE devices
- 4 x SATA 3Gb/s connectors (SATAII0, SATAII1, SATAII2, SATAII3) supporting up to 4 SATA 3Gb/s devices
- Support for SATA RAID 0, RAID 1 and RAID 0+1
- iTE IT8718 chip: 1 x floppy disk drive connector supporting up to 1 floppy disk drive

IEEE 1394:

- T.I. TSB43AB23 chip
- Up to 3 IEEE 1394a ports (2 on the back panel, 1 via the IEEE 1394a bracket connected to the internal IEEE 1394a headers)

USB:

- Integrated in the South Bridge
- Up to 10 USB 2.0/1.1 ports (6 on the back panel, 4 via the USB brackets connected to the internal USB headers)

Internal I/O Connectors:

- 1 x 24-pin ATX main power connector
- 1 x 4-pin ATX 12V power connector
- 1 x floppy disk drive connector
- 1 x IDE connector
- 4 x SATA 3Gb/s connectors
- 1 x CPU fan header
- 2 x system fan headers
- 1 x power fan header
- 1 x North Bridge fan header
- 1 x front panel header
- 1 x front panel audio header
- 1 x CD In connector
- 1 x S/PDIF In header
- 1 x S/PDIF Out header
- 2 x USB 2.0/1.1 headers
- 1 x IEEE 1394a header
- 1 x parallel port header
- 1 x power LED header
- 1 x chassis intrusion header

Back Panel Connectors:

- 1 x PS/2 keyboard port
- 1 x PS/2 mouse port
- 1 x coaxial S/PDIF Out connector
- 1 x optical S/PDIF Out connector
- 1 x serial port
- 6 x USB 2.0/1.1 ports
- 2 x IEEE 1394a ports
- 1 x RJ-45 port
- 6 x audio jacks (Center/Subwoofer Speaker Out/Rear Speaker Out/Side Speaker Out/Line In/Line Out/Microphone)

I/O Controller:

- iTE IT8718 chip

H/W Monitoring:

- System voltage detection
- CPU/System temperature detection
- CPU/System/Power fan speed detection
- CPU overheating warning
- CPU/System/Power fan fail warning
- CPU fan speed control

Form Factor:

- ATX Form Factor: 30.5cm x 21.0cm

  It is highly recommended to always use the most recent driver version available.

Try to set a system restore point before installing a device driver. This will help if you installed an incorrect or mismatched driver. Problems can arise when your hardware device is too old or not supported any longer.

Related REALTEK Drivers