Gigabyte GA-MA78G-DS3H (rev. 1.0) Realtek LAN Driver 5.792.1208.2011 Download

Posted at December 22, 2024 by PCI-DB Team

Gigabyte GA-MA78G-DS3H (rev. 1.0) Realtek LAN Driver 5.792.1208.2011 Description

Specifications:

CPU:
- Support for Socket AM3 / AM2+ / AM2 processors: AMD PhenomFX processor/ AMD Phenom processor/ AMD Athlon 64 FX processor/AMD Athlon 64 X2 Dual-Core processor/AMD Athlon 64 processor/AMD Sempron processor

Hyper Transport Bus:

- 5200/2000 MT/s

Chipset:

- North Bridge: AMD 780G
- South Bridge: AMD SB700

Memory:

- 4 x 1.8V DDR2 DIMM sockets supporting up to 16 GB of system memory
- Dual channel memory architecture
- Support for DDR2 1066/800/667 MHz memory modules

Audio:

- Realtek ALC889A codec
- High Definition Audio
- 2/4/5.1/7.1-channel
- Support for S/PDIF In/Out
- Support for CD In

LAN:

- Realtek 8111C chip (10/100/1000 Mbit)

Expansion Slots:

- 1 x PCI Express x16 slot (Note3), confirming to PCI Express 2.0 standard
- 1 x PCI Express x4 slot, confirming to PCI Express 2.0 standard
- 3 x PCI Express x1 slot (PCIEX1_2, PCIEX1_3 share with the PCIEX4_1 slot) (Note4)
- 2 x PCI slots

Storage Interface:

- 1 x IDE connector supporting ATA-133/100/66/33 and up to 2 IDE devices
- 6 x SATA 3Gb/s connectors supporting up to 6 SATA 3Gb/s devices
- Support for SATA RAID 0, RAID 1 and RAID 10 and JBOD
- iTE IT8718 chip: 1 x floppy disk drive connector supporting up to 1 floppy disk drive

IEEE 1394:

- T.I. TSB43AB23 chip
- Up to 3 IEEE 1394a ports (1 on the back panel, 2 via the IEEE 1394a bracket connected to the internal IEEE 1394a header)

USB:

- Integrated in the South Bridge
- Up to 12 USB 2.0/1.1 ports (4 on the back panel, 8 via the USB brackets connected to the internal USB headers)

Internal I/O Connectors:

- 1 x 24-pin ATX main power connector
- 1 x 4-pin ATX 12V power connector
- 1 x floppy disk drive connector
- 1 x IDE connector
- 6 x SATA 3Gb/s connectors
- 1 x CPU fan header
- 2 x system fan header
- 1 x power fan header
- 1 x front panel header
- 1 x front panel audio header
- 1 x CD In connector
- 1 x S/PDIF In/Out header
- 2 x IEEE 1394a header
- 4 x USB 2.0/1.1 headers
- 1 x parallel port header
- 1 x serial port header
- 1 x chassis intrusion header
- 1 x power LED header

Back Panel Connectors:

- 1 x PS/2 keyboard port
- 1 x PS/2 mouse port
- 1 x D-Sub port
- 1 x DVI-D port
- 1 x HDMI port
- 1 x optical S/PDIF Out connector
- 1 x IEEE 1394a port
- 4 x USB 2.0/1.1 ports
- 1 x RJ-45 port
- 6 x audio jacks (Center/Subwoofer Speaker Out/Rear Speaker Out/Side Speaker Out/Line In/Line Out/Microphone)

I/O Controller:

- ITE IT8718 chip

H/W Monitoring:

- System voltage detection
- CPU/System temperature detection
- CPU/System fan speed detection
- CPU overheating warning
- CPU/System fan fail warning
- CPU/System fan speed control

Form Factor:

- ATX Form Factor: 30.5cm x 22.8cm

  It is highly recommended to always use the most recent driver version available.

Try to set a system restore point before installing a device driver. This will help if you installed an incorrect or mismatched driver. Problems can arise when your hardware device is too old or not supported any longer.

Related REALTEK Drivers