ADATA SX900 Solid State Drive Firmware 5.0.7a Download

Posted at November 2, 2024 by PCI-DB Team

ADATA SX900 Solid State Drive Firmware 5.0.7a Description

Fixes:

1. Fixed a power management condition where the device failed to respond to COMWAKE, which might have resulted in the SSD not responding without being reset by the host.
2. Fixed the normalized value calculation for SMART Attribute 9 (Power-On Hours)
3. Fixed a SATA error recovery sequence coming out of PS1.
4. Fixed an issue during SMART self-test extended that could cause an unexpected read error.
5. Fixed an issue that could have caused the read thresholds to be artificially low during read disturb operations.
6. Fixed an issue that could have caused the drive to be unresponsive based on a flash program failure.
7. Fixed a theoretically possible instance where an UECC on the flash media while processing unaligned write commands that cannot be corrected by the ECC engine and RAISETM causes invalid data to be returned.

  It is highly recommended to always use the most recent driver version available.

Try to set a system restore point before installing a device driver. This will help if you installed an incorrect or mismatched driver. Problems can arise when your hardware device is too old or not supported any longer.

Related ADATA Drivers