Gigabyte GA-MA790FX-UD5P (rev. 1.0) SATA2 Preinstall Driver 1.17.50.2 x64 Download

Posted at December 26, 2024 by PCI-DB Team

Gigabyte GA-MA790FX-UD5P (rev. 1.0) SATA2 Preinstall Driver 1.17.50.2 x64 Description

Specifications:

- CPU
Support for AM3 / AM2+ / AM2 processors: AMD Phenom II X3 processor/AMD Phenom II X4 processor AMD Phenom FX processor/AMD Phenom X4 processor/AMD Phenom X3 processor/AMD Athlon X2 processor/AMD Athlon processor/AMD Sempron X2 processor/ AMD Sempron processor
Hyper Transport Bus
5200/2000 MT/s

- Chipset
North Bridge: AMD 790FX
South Bridge: AMD SB750

- Memory
4 x 1.8V DDR2 DIMM sockets supporting up to 16 GB of system memory
Dual channel memory architecture
Support for DDR2 1333(O.C.)/1066/800 MHz memory modules

- Audio
Realtek ALC889A codec
High Definition Audio
2/4/5.1/7.1-channel
Support for Dolby Home Theater
Support for S/PDIF In/Out
Support for CD In

- LAN
2 x Realtek 8111DL chip (10/100/1000 Mbit)
Support for Teaming

- Expansion Slots
2 x PCI Express x16 slots, running at x16 (The PCIEX16_1 and PCIEX16_2 slots support ATI CrossFireX technology, and conform to PCI Express 2.0 standard.)
3 x PCI Express x1 slots
2 x PCI slots

- Storage Interface
South Bridge:
1 x IDE connector supporting ATA-133/100/66/33 and up to 2 IDE devices
6 x SATA 3Gb/s connectors supporting up to 6 SATA 3Gb/s devices
Support for SATA RAID 0, RAID 1, RAID5, RAID 10 and JBOD
GIGABYTE SATA2 chip:
2 x SATA 3Gb/s connectors (GSATA2_0, GSATA2_1) supporting up to 2 SATA 3Gb/s devices
Support for SATA RAID 0, RAID 1 and JBOD
ITE 8720 chip:
1 x floppy disk drive connector supporting up to 1 floppy disk drive

- IEEE 1394
T.I. TSB43AB23 chip
Up to 3 IEEE 1394a ports (2 on the back panel, 1 via the IEEE 1394a bracket connected to the internal IEEE 1394a header)

- USB
Integrated in the South Bridge
Up to 12 USB 2.0/1.1 ports (8 on the back panel, 4 via the USB brackets connected to the internal USB headers)

- Internal I/O Connectors
1 x 24-pin ATX main power connector
1 x 8-pin ATX 12V power connector
1 x floppy disk drive connector
1 x IDE connector
8 x SATA 3Gb/s connectors
1 x CPU fan header
2 x system fan header
1 x power fan header
1 x North Bridge fan header
1 x front panel header
1 x front panel audio header
1 x CD In connector
1 x S/PDIF In/Out header
1 x IEEE 1394a header
2 x USB 2.0/1.1 headers
1 x serial port header
1 x parallel port header
1 x chassis intrusion header
1 x power LED header
1 x power switch
1 x reset switch
1 x clearing CMOS switch

- Back Panel Connectors
1 x PS/2 keyboard port
1 x PS/2 mouse port
1 x optical S/PDIF Out connector
1 x coaxial S/PDIF out connector
2 x IEEE 1394a port
8 x USB 2.0/1.1 ports
2 x RJ-45 port
6 x audio jacks (Center/Subwoofer Speaker Out/Rear Speaker Out/Side Speaker Out/Line In/Line Out/Microphone)

- I/O Controller
ITE IT8720 chip

- H/W Monitoring
System voltage detection
CPU/System temperature detection
CPU/System fan speed detection
CPU overheating warning
CPU/System fan fail warning
CPU/System fan speed control

- BIOS
2 x 8 Mbit flash
Use of licensed AWARD BIOS
Support for DualBIOS
PnP 1.0a, DMI 2.0, SM BIOS 2.4, ACPI 1.0b

  It is highly recommended to always use the most recent driver version available.

Try to set a system restore point before installing a device driver. This will help if you installed an incorrect or mismatched driver. Problems can arise when your hardware device is too old or not supported any longer.

Related GIGABYTE Drivers