YONGNUO YN-622N-TX i-TTL Wireless Flash Controller Firmware 1.03 Download

Posted at December 22, 2024 by PCI-DB Team

YONGNUO YN-622N-TX i-TTL Wireless Flash Controller Firmware 1.03 Description

Fimrware upgrade instructions:

1. When you prepare to upgrade YN-622N-TX first time, please download the driver and software package YN_Trigger_Updater.zip, uncompress it and run YN_Trigger_Updater_Setup.exe to install the driver/software.
2. Download the most update firmware package and unzip it.
3. Turn off YN-622N-TX, keep pressing mode button and turn on it again. The screen will show firmware upgrade interface . Connect the device to your PC via a USB cable.
4. Run YN_Trigger_Updater from start menu. Click on "Browse..." Button and navigate to the firmware you download in step 2. Wait a few seconds until the device is detected. Click on "Update" to begin. When is done, YN-622N-TX will be reset automatically and you can use the new version now.
5. If any error is encountered when updating, please turn off and try again from step 3.

  It is highly recommended to always use the most recent driver version available.

Try to set a system restore point before installing a device driver. This will help if you installed an incorrect or mismatched driver. Problems can arise when your hardware device is too old or not supported any longer.

Related Others Drivers