Buffalo WHR-300HP2 Router Firmware 1.60 Download

Posted at November 21, 2024 by PCI-DB Team

Buffalo WHR-300HP2 Router Firmware 1.60 Description

Fixes:

- Fixed the issue where the AirStation sometimes replies to Address Resolution Protocol (ARP) requests from the Internet.
- Fixed the issue where a subnet mask cannot be configured correctly sometimes in routing settings.
- Fixed the issue where routing cannot be configured correctly sometimes.
- Fixed the issue where the Internet transmission rate sometimes drops.
- Fixed the issue where the PPPoE connection sometimes stops after the AirStation reboots.
- Fixed the issue with UPnP sometimes not working with some STBs.
- Fixed the issue where some router settings cannot be configured sometimes when the AirStation boots without an Internet connection.
- Modified to assign Automatic Private IP Addressing (APIPA) when the AirStation cannot obtain the IP address from the DHCP server while it is in the bridge mode.
- Fixed the contents of DDNS logs.
- Fixed the issue where the WAN-side IP address characters became corrupted in port forwarding settings when using a PPPoE connection.
- Deleted an unnecessary sentence in the Internet connection wizard.

  It is highly recommended to always use the most recent driver version available.

Try to set a system restore point before installing a device driver. This will help if you installed an incorrect or mismatched driver. Problems can arise when your hardware device is too old or not supported any longer.

Related Buffalo Drivers