Ricoh PX Digital Camera Firmware 1.11 for XP/Vista Download

Posted at December 21, 2024 by PCI-DB Team

Ricoh PX Digital Camera Firmware 1.11 for XP/Vista Description

Fixes:

When an Eye-Fi card is inserted in the camera, and if you are going to begin shooting movies immediately after the camera starts up, the movie shooting may not start.

Firmware installation steps:

1. Copy the firmware to the SD memory card.
2. Remove the SD memory card from the PC card reader/card slot and insert it into the camera
3. Turn on the camera
4. Press the MENU/OK button
5. Select [Adv.shooting options] in [Quick shooting menu] and press the MENU/OK button
6. Press the left button and then the down button to display [Setup]. Press the right button and then the up button to select [Check Firmware Ver.], and press the right button.
- A message confirming the firmware update will appear on the picture display.
- If the confirmation message does not appear, confirm whether the firmware file has been properly saved on the SD memory card.
7. Press the right button to select [Yes] and press the MENU/OK button.
- The firmware update will start, and the message shown below will display on the picture display.The firmware update should take about 30 seconds to complete.
- When the update is complete, the camera will restart.
8. Confirm that the updated version is displayed in the picture display.
9. Turn off the camera.

About Digital Camera Firmware:

Updating to a newer firmware version than the one already installed on your camera can improve the device’s overall performance and stability, resolve various issues, and add support for newly developed features or enhance existing ones.

On the other hand, downgrading the camera’s firmware can recover its functionality in the unlikely event the currently installed version is faulty or the device’s performance dropped after an upgrade. However, bear in mind that applying an earlier build might not always be possible.

It is recommended that changing the camera’s firmware be performed when the new release resolves an issue that your device has been encountering, or adds a new feature (or enhances an existing one) that could prove useful for you.

This process isn’t intended to be destructive, but still, it’s best to save all your personal data and configurations before applying a different firmware. Moreover, make sure that the battery is fully charged and don’t use the camera’s buttons while the installation is in progress.

When it comes to the update method, usually, you must copy the firmware file onto a compatible memory card, insert it into the camera, and browse from the menu to the device’s update section.

However, each device has various ways to enter the update mode and particular steps that should be taken for a successful upgrade, therefore make sure you read the product’s installation guide.

That being said, if you consider that this firmware improves your device in any way, then hit the download button and get the desired version; if not, check with our website as often as possible so that you don’t miss the update that will boost your camera’s performance.
9. Turn off the camera
 

  It is highly recommended to always use the most recent driver version available.

Try to set a system restore point before installing a device driver. This will help if you installed an incorrect or mismatched driver. Problems can arise when your hardware device is too old or not supported any longer.

Related Ricoh Drivers