Nikon Df Camera Firmware C:1.01 Download

Posted at December 22, 2024 by PCI-DB Team

Install Driver Automatically

Device Name	Nikon Df Camera Firmware C:1.01
Category	Scanner Digital Camera Webcam
Manufacturer	Nikon
File Size	10 MB
Supported OS	Windows All

Nikon Df Camera Firmware C:1.01 Description

Fixes:
- When Press for Custom Setting f4 (Assign Fn button) , f5 (Assign preview button) , or f6 (Assign AE-L/AF-L button) was set to Preview, and the camera's Fn button, Pv button, or AE-L/AF-L button was pressed, while viewfinder shooting using a Speedlight SB-800, a preview was not displayed in the camera monitor and a modeling flash was not fired. This issue has been resolved.
- When a Speedlight that does not support Auto FP high-speed sync was used with Custom Setting e1 (Flash sync speed) set to 1/250 s (Auto FP), the maximum shutter speed was 1/200 s. This issue has been resolved.
- When images captured with Auto ISO sensitivity control in the shooting menu set to Off were displayed in ViewNX 2 or Capture NX 2, Auto (ISO XXX) was incorrectly displayed for ISO Sensitivity in Metadata. This issue has been resolved.

Confirming the firmware version:

- Turn on the camera.
- Press the MENU button and select Firmware Version from the setup menu.
- The camera's firmware version will be displayed.
- Turn off the camera.

Basic Upgrade instructions:

- Create a new folder with an appropriate name on your computer.
- Choose the correct download below for the computer system you are using below, and save the download to the folder created.
- Run the downloaded file to create the folder titled DFUpdate, containing the following file: DF_0101.bin .
- Format an approved memory card in the camera, then remove.
- Copy the DF_0101.bin file to the top level of the memory card using a memory card reader or similar device, do not copy the file into any folder on the memory card.
- Insert memory card into the cameras memory card slot, and switch on.
- Select Firmware Version from the setup menu and follow the instructions displayed to upgrade the camera's firmware.
- DO NOT switch off the camera at any time during the update, doing so may result in the need for service.
- After the upgrade is complete, trun the camera off and remove the memory card.
- Check the cameras firmware version to be sure it completed.
- Format memory card in camera for use.

  It is highly recommended to always use the most recent driver version available.

Try to set a system restore point before installing a device driver. This will help if you installed an incorrect or mismatched driver. Problems can arise when your hardware device is too old or not supported any longer.

Related Nikon Drivers