Mellanox BX5020 rev.A1 Gateway Firmware 8.5.0000 Download

Posted at December 22, 2024 by PCI-DB Team

Mellanox BX5020 rev.A1 Gateway Firmware 8.5.0000 Description

New Features:

- Added support for "ALL VLAN" vHub
- Increased the buffer size of VL15 to avoid packets’ drops
- Added support for filtering LLDP packets to FabricIT BXM
- Added Shared context table option - 5k vNICs
- Added DCBX support of receiving DCBX packets with a VLAN tag
- Added the ability to send FabricIT BXM Advertisement and Multicast vNIC alive messages
- Added the ability to send packets from external Ethernet ports to FabricIT BXM to enable LACP
- Modified SL2VL mapping to enables changes on the fly
- Added different tx serdes sets for different cables capability
- Added FCoE frame aging
- Added the ability to control external module tx_disable
- Added a verification test to check if the external Phy module exists only in PhyX mode
- Enabled 4th Fibre Channel port in FCoE
- Added bits for clause37 page timer
- Added offset calibration to rx training in Ethernet
- Added the ability to reset to cl37_active and idle_active in clause37 flow upon link failure
- Sent IDLEs and CL37 pages to work with Finisar and Delta modules
- Changed vl_arb_low_cap vl_arb_high_cap in port info mad
- Added the ability to compare application tlv in DCBX
- Added Fibre Channel counters: frames lost, r_rdys lost
- Added clause37 flow fix - Added phy_type indication for int port in device internal pib, flow checked sgmii linkup

Bug Fixes:

- Fixed an issue with the Fibre Channel RX adaptation flow.
- Fixed an issue with the software reset flow.
- Fixed an issue with the TrapRepress.

  It is highly recommended to always use the most recent driver version available.

Try to set a system restore point before installing a device driver. This will help if you installed an incorrect or mismatched driver. Problems can arise when your hardware device is too old or not supported any longer.

Related Mellanox Drivers