EVGA Z97 Stinger Core 3D BIOS 1.08 Download

Posted at November 5, 2024 by PCI-DB Team

EVGA Z97 Stinger Core 3D BIOS 1.08 Description

BIOS 1.08 Updates:

- Adds support for G3258 CPU overclocking

Windows Installation:

- Download the correct .zip file for your motherboard
- First go into your BIOS and load defaults, save and exit
- Close all open programs.
- Go into the folder where you unzipped this package and update.bat
- Press Y to start the flash process
- DO NOT TURN OFF POWER OR RESET DURING THE FLASH PROCESS
- After the flashing is finished, the system will automatically shut down. Then power on again and go into BIOS to setup.
- NOTE: If flash box immediately closes after flash attempt, the flash may need to be ran from a CMD prompt with administrator privileges or DOS version.

BIOS Installation:

- Extract the contents of .zip file to USB flash drive (must be formatted as FAT32)
- Reboot the machine and go into the system BIOS
- From the BIOS, navigate to the Save & Exit tab and open "Select BIOS File."
- Select the .bin file you wish to flash.
- After the flashing is finished, shut the system down completely. Then power on again.
- After flashing verify that the correct flash was applied by checking the version number on the lower right corner of the BIOS screen.

  It is highly recommended to always use the most recent driver version available.

Try to set a system restore point before installing a device driver. This will help if you installed an incorrect or mismatched driver. Problems can arise when your hardware device is too old or not supported any longer.

Related EVGA Drivers