MikroTik RouterOS x86 Firmware 6.33.6 Download

Posted at December 26, 2024 by PCI-DB Team

MikroTik RouterOS x86 Firmware 6.33.6 Description

What's new in 6.33.6:

- winbox - show properly route-distinguisher for bgp vpn4;
- winbox - show dhcp server name in dhcp leases;
- ppp - make CoA work correctly with address-lists;
- winbox - fixed tab names to correspond to console;
- winbox - show only actual switch-cpu ports in switch setting combobox;
- winbox/webfig - fixed version column ordering in ip neighbors list;
- webfig - fixed switch port "default vlan id" has missing "auto" value;
- webfig - fixed firewall connection-bytes option;
- ipsec - fixed kernel failure after underlying tunnel has been disabled/enabled;
- romon - allow to see device identity if it is longer than 31 character;
- fastpath - show fp counters in /interface monitor aggregate;
- bridge firewall - fix chain check (broken since 6.33.2);
- bridge firewall - fixed crash when jump rule points to disabled custom chain;
- smb - fix crash when changing user which has open session;
- address-list - properly remove unused address-lists from drop-downs;
- fetch - fixed closure after 30 seconds;
- capsman - fix radius accounting stop message;
- log - reopen log file if deleted;
- packing - fix tcp/udp checksums when simple packing is used;
- tile - fix ipsec freeze after SA updates;
- upnp - fixed missing in-interface option for dynamic dst-nat rules;
- tunnel - fix complaining about loop after ~248 days;
- vrrp - make sure that VRRP gets state on bootup;
- ppp - fixed rare kernel crash (introduced in v6.33);
- ppp - do not allow empty name ppp secrets;
- ssh - fix active user accounting.

About Router Firmware:

Before you consider downloading this firmware, go to the system information page of the router and make sure that the currently installed version isn’t either newer or matching this release.

Due to the large variety of router models and different methods for upgrading the device, it is highly recommended that you read and, above all, understand the installation steps before you apply the new firmware, even if you are a power user.

In theory, these steps shouldn’t be much of a hassle for anyone, because manufacturers try to make them as easy as possible, even if they don’t always succeed. Basically, you must upload the new firmware to the router through its administration page and allow it to upgrade.

If you install a new version, you can expect increased security levels, different vulnerability issues to be resolved, improved overall performance and transfer speeds, enhanced compatibility with other devices, added support for newly developed technologies, as well as several other changes.

If you’re looking for certain safety measures, remember that it would be best if you perform the upload using an Ethernet cable rather than a wireless connection, which can be interrupted easily. Also, make sure you don’t power off the router or use its buttons during the installation, if you wish avoid any malfunctions.

If this firmware meets your current needs, get the desired version and apply it to your router unit; if not, check with our website as often as possible so that you don’t miss the update that will improve your device. 

  It is highly recommended to always use the most recent driver version available.

Try to set a system restore point before installing a device driver. This will help if you installed an incorrect or mismatched driver. Problems can arise when your hardware device is too old or not supported any longer.

Related MikroTik Drivers