Edimax PT-31E Network Camera Firmware 1.02.04 Download

Posted at December 21, 2024 by PCI-DB Team

Edimax PT-31E Network Camera Firmware 1.02.04 Description

3Mpx PoE Day & Night PT Network Camera

- 5 megapixel CMOS sensor
- Motorized pan and tilt
- Night vision with built-in IR LED (up to 10 meters)
- QXGA resolution at 20fps, 1080p resolution (full HD) at real-time 30fps
- H.264, MPEG-4 & M-JPEG multi-stream output
- Simultaneous live monitoring and high resolution recording
- Multi-area motion detection
- Support IEEE802.3af Power-over-Ethernet (PoE) standard
- SD/SDHC memory card slot for local storage
- 2-way audio support

Fixes:

Web:
1. Revise the fail of Restore configuration
2. Set 0.0.0.0 as acceptable netmask
3. Remove the debug message when DDNS pops up
4. Fix image overlap when using Safari as management interface
5. Fix the improper display of Motion Satus bar

OCX :
1. Allow image showing in the 2nd session simultaneously
2. Improve MJPG (RTSP) and Win7 media player compatibility
3. OCX shows connecting message while network reconnects
4. Improve MPEG4 (RTSP/HTTP) and media player compatibility
5. Motion Window disappears

FW:
1. Device should have default DNS IP address before getting IP address from DHCP
2. Revise UPNP function
3. Improve the compatibility of HTTP MJPG record and media player
4. Define Non-supported GPIO sending back HTTP streaming header default=1 such as SIU7110 GPI2, SIU5110 GPI and GPO
5. Revise Event Schedule Time Check function
6. Resend RTSP MPEG4 VOL in order to keep the image stream in the 2nd OCX connection
7. Enable frame rate ? 20fps in param.cgi MJPEG 720P mode
8. MJPEG frame rate should refer to the defaul value but not 30fps when AV server reboots
9. Keep enough time for firmware upgrade completely

About Network Camera Firmware:

Applying the appropriate software for your network camera helps computers properly connect with the device, and adds support for various surveillance features that the camera benefits from (such as monitoring specific areas).

If you’re considering a software upgrade, you should know that this process might improve the unit’s overall performance and stability, add support for new features (or enhance existing ones), or include fixes for various issues. However, bear in mind that not all software updates bring significant changes.

As for the installation method, the steps vary depending on the type of software that you are about to apply; so, make sure you carefully read and understand the installation steps so that you don’t end up with a broken device.

If you're thinking about applying this software version, hit the download button and update your camera once you have familiarized yourself with the installation method. In addition to that, don’t forget to check with our website as often as possible so that you don’t miss a single new release. 

  It is highly recommended to always use the most recent driver version available.

Try to set a system restore point before installing a device driver. This will help if you installed an incorrect or mismatched driver. Problems can arise when your hardware device is too old or not supported any longer.

Related Edimax Drivers