Buffalo TS-2RZS NAS Firmware 2.41 Download

Posted at April 19, 2024 by PCI-DB Team

Buffalo TS-2RZS NAS Firmware 2.41 Description

New Freatures: [System]

- Added CPU and memory utilization in the system information.

Fixes: [System]

- Fixed a bug where the existing group privilege was changed to general users group when rebooting the TeraStation.
- Fixed a bug where a complete format did not run if a media cartridge exists in the array.
- Fixed a bug where email notification sent the same two emails after the firmware updates to version 2.40.
- Fixed a bug where some settings were not copied during failover.

Fixes: [RAID]

- Fixed a bug where a drive error occurred on a hot spare drive when the RAID array was scanned.
- Fixed a bug where the RAID array could not be deleted if LVM or a hot spare was enabled.
- Fixed a bug where the Settings interface did not display properly if the RAID array was rebuilt with a hot spare drive.

Fixes: [Amazon S3]

- Fixed a bug where file updates to Amazon S3 sometimes failed.
- Improved to display "error" as a status when a connection error occurred.
- Fixed a bug where Amazon S3 was not automatically disabled if the target folder was deleted.

  It is highly recommended to always use the most recent driver version available.

Try to set a system restore point before installing a device driver. This will help if you installed an incorrect or mismatched driver. Problems can arise when your hardware device is too old or not supported any longer.

Related Buffalo Drivers