Edimax CAP1200 Switch Firmware 1.3.12 Download

Posted at April 27, 2024 by PCI-DB Team

Edimax CAP1200 Switch Firmware 1.3.12 Description

24-Port Gigabit PoE+ with 4 SFP Slots Web Smart Switch

- IEEE 802.3af/at PoE compliant.
- Twenty-four Gigabit Ethernet ports and four mini-GBIC/SFP slots.
- Up to 30W per port (total power budget: 400W) for powering PoE-enabled devices.
- Auto-detection of powered devices (PD) and power consumption levels.
- Auto fault-detection on over/under current & voltage.
- Access Control List (ACL) support.
- Switch capacity:56Gbps & Forwarding rate:35.7Mbps.
- IEEE 802.1Q-based VLAN for network segmentation to improve performance and security.
- IGMP Snooping V1 / V2 support.
- 8K MAC address table and jumbo frame support up to 9KB.
- 19-inch 1U rack-mount.

Fixes

- [AP mode] Fixed SNMP cannot get VLAN group value (vlanType and vlanID).
- [AP mode] Fixed SNMP get wrong format in system description.
- [AP mode] Fixed Airplay connection issue.
- [NMS mode] Fixed When user click Restart function that it need to double confirm and warning message
- [NMS mode] Fixed if the CAP1200 change IP address mode form DHCP client to static IP and then you cannot access CAP1200 anymore.
- [NMS Mode] Fixed 5GHz Wireless auto pilot function always run on Band1 channel
- [NMS mode] Fixed NMS Firmware upgrade issue with CAP1200
- [NMS mode] Fixed wireless active client "Search" function issue

Modifications

- change SNMP default value from disable to enable
- [NMS mode] Disable auto pilot function for NMS mode default setting
- [NMS mode] auto pilot channel setting add new item for channel 1,6,11 only

New Feature

- Added IGMP ON/OFF feature.
- [AP Mode] Support Repeater mode
- [NMS mode] Allow users to change the HTTP port number.
- [NMS mode] Event Log support sorting item function
- [NMS mode] Support wireless schedule function

About Switch Firmware:

Given the large variety of models and different methods for upgrading the switch, if you wish to apply this package, we recommend that you read and understand the installation steps before you install a new firmware, even if you are a power user.

Usually the update procedure isn’t much of a hassle as manufacturers try to make it as simple as possible; however, there are cases that are exceptions to this rule. First off, go to the system information page of the switch to check that the currently installed version isn’t either newer or matching this release.

Applying a new firmware can decrease the security vulnerabilities, enhance overall performance and compatibility, improve various power management functions, resolve different errors, and add support for newly developed technologies and protocols.

It is recommended that you perform this step in a steady power environment such as the one ensured by a UPS unit, and that you don’t interrupt the upgrade in any way, because this might cause the switch to malfunction.

That being said, click the download button, get and apply the new version, and check back with our website constantly to stay up to speed with the latest releases. 

  It is highly recommended to always use the most recent driver version available.

Try to set a system restore point before installing a device driver. This will help if you installed an incorrect or mismatched driver. Problems can arise when your hardware device is too old or not supported any longer.

Related Edimax Drivers