Onkyo TX-NR737 AV Receiver Firmware 2000-5110-1001-0401-0102 Download

Posted at November 21, 2024 by PCI-DB Team

Onkyo TX-NR737 AV Receiver Firmware 2000-5110-1001-0401-0102 Description

Fixes:

- Adds support of Dolby Atmos

Precautions for TX-NR737 Firmware Update:

- The firmware update should take 30 to 40 minutes. Once the update begins, don't turn off the power supply to the A/V receiver until it is time to restart it
- Depending on the conditions of the network, a firmware update via a network may take more than one hour or even fail to finish. If the update is not completed within two hours, turn off the power supply by pushing the ON/STANDBY button and then try updating again from the beginning
- Updating the firmware and adjusting the settings will be done automatically, but may take some time to complete
- If your A/V receiver is damaged for any of the reasons above, an Onkyo service center will repair the unit for a fee

Note that the update may fail, or cause problems for your A/V receiver, if you do any of the following:

- Pull out the A/V receiver's power cord
- Interrupt the power supply to the A/V receiver (e.g. if the breaker is tripped or if there is an electrical outage)
- Insert or remove the LAN cable from a device in your network when updating over a network
- Insert or remove a USB memory device from the A/V receiver when updating via USB
- Operate components connected to the A/V receiver via HDMI, such as a TV or a recording device

  It is highly recommended to always use the most recent driver version available.

Try to set a system restore point before installing a device driver. This will help if you installed an incorrect or mismatched driver. Problems can arise when your hardware device is too old or not supported any longer.

Related Onkyo Drivers