HP ProLiant MicroServer Gen8 iLO 4 Firmware 2.00 64-bit Download

Posted at November 21, 2024 by PCI-DB Team

HP ProLiant MicroServer Gen8 iLO 4 Firmware 2.00 64-bit Description

Fixes:

- The error "Max number of certificates has been reached" occurs when SSO certificates are imported.
- The iLO Shared Network Port cannot be enabled for embedded LOM via the ROM-based setup utility or iLO web interface.
- iLO cannot be enabled via the iLO RBSU if it was disabled by using the iLO 4 Configuration Utility in the UEFI System Utilities.
- DHCP options can be modified via the ROM-based setup utility when DHCP is disabled.
- The System Information Health Summary page shows an Undefined error message on DL380p Gen8 servers.
- iLO requires a reset for IPv6 Multicast Scope changes.
- The iLO clock is one hour fast during Daylight Savings Time when it is configured by the ROM-based setup utility or the Insight Management Agents.
- The power supply status for an installed power supply is incorrectly displayed as "Not installed" on the System Information Power Information page in the iLO web interface.
- An error message is not displayed when an invalid Gateway IPv4 address is configured.
- Users without the Configure iLO Settings privilege can modify iLO ROM-based setup utility settings.
- The character limit for the Server Name is inconsistent between the iLO web interface and the CLI.
- The power supply status shows Failed/Good, In Use when the power cord is removed from the server.
- Embedded Remote Support fails after sending a second test service event.
- The iLO Firmware cannot be updated via the Group Firmware Update feature.
- The 24-hour power graph does not include all available power data.
- Characters are missing on the Group Virtual Media page after a disk image is connected through a URL.
- The Login Security Banner display on the Login page is incomplete.
- The CLI hangs after Virtual Media is mounted through a URL.

Enhancements: Gen 9 ProLiant Servers Only

- Manual iLO reboot via the server UID button—Allows you to use the server UID button to initiate a graceful iLO reboot or a hardware iLO reboot.
- HP ProLiant Pre-boot Health Summary—Displays diagnostic information on the server monitor when the server is off and power is available.
- 1 GB Embedded User Partition—Allows you to use a 1 GB non-volatile flash memory partition as if it was an SD-card attached to the server.

Enhancements: Gen 8 and Gen 9 ProLiant Servers

- iLO Federation Group License Activation—Supports license key installation on multiple systems.
- Group configuration for iLO Federation Groups—Allows you to configure groups for the systems in an iLO Federation Management group. Configuring the group memberships of individual systems is still supported.
- HP RESTful API—The HP RESTful API is a management interface that server management tools can use to perform configuration, inventory, and monitoring of an HP ProLiant server via iLO.

Feature previews:

- Shared Network Port port selection—Allows you to choose between port 1 and port 2 for Shared Network Port functionality. You can configure this setting on the Network > Shared Network Port > General page in the iLO web interface.
- NOTE: Not all sideband NICs are supported. In some cases, port 2 might not be fully functional.
- iLO network connection auto-select—Allows you to configure iLO to automatically select the iLO Dedicated Network Port or Shared Network Port, based on the detected network activity. This feature can be configured by using the iLO CLI or XML scripting.

  It is highly recommended to always use the most recent driver version available.

Try to set a system restore point before installing a device driver. This will help if you installed an incorrect or mismatched driver. Problems can arise when your hardware device is too old or not supported any longer.

Related HP Drivers