Dell Dimension 4600 1901FP Monitor Driver 1.0 Download

Posted at November 2, 2024 by PCI-DB Team

Dell Dimension 4600 1901FP Monitor Driver 1.0 Description

Specificiations:

- Processor
Intel Pentium 4 that runs at 2.26, 2.4, 2.533, 2.66, 2.8, or 3.06 GHz internally and 533 MHz externally, or 2.4, 2.6, 2.8, 3.0, 3.2, or 3.4 GHz internally and 800 MHz externally
Level 1 (L1) cache: 8 KB first-level
Level 2 (L2) cache: 512-KB or 1-MB pipelined-burst, eight-way set associative, write-back SRAM

- System Information
System chip set: Intel 865PE or 865G
DMA channels: eight
Interrupt levels: 24 APIC mode
System BIOS chip: 4 Mb (512 KB)
System clock: 533- or 800-MHz data rate

- Expansion Bus
Bus types: PCI
Bus speed: PCI: 33 MHz
PCI connectors: three
PCI connector size: 120 pins
PCI connector data width (maximum): 32 bits
AGP: AGP 1X, 4X, 8X

- Memory
Architecture: Dual Channel DDR SDRAM
Memory connectors: Four
Memory capacities: 128-, 256-, 512-MB or 1-GB
Minimum memory: 128-MB DDR SDRAM
Maximum memory: 4 GB
Memory type: PC2700 (333-MHz) or PC3200 (400-MHz) DDR SDRAM (non-ECC)

- Drives
Externally accessible
two 5.25-inch bays
one 3.5-inch bay
Internally accessible
Two bays for 1-inch–high IDE hard drives

- Ports and Connectors
Externally accessible:
Serial: 9-pin connector; 16550C-compatible
Parallel: 25-hole connector (bidirectional)
Video: 15-hole connector
Keyboard: 6-pin mini-DIN connector
Mouse: 6-pin mini-DIN connector
USB: two front-panel and six back-panel USB 2.0–compliant connectors
Network: RJ-45 connector
Audio: Five back miniature connectors for line-in, line-out, microphone, surround and center/Low-Frequency Effects (LFE) channel
Headphone: one front miniature connector for line-out Internally accessible:
Primary IDE channel: 40-pin connector on PCI local bus
Secondary IDE channel: 40-pin connector on PCI local bus
Floppy drive: 34-pin connector
Serial ATA: two 7-pin connectors

- Video
Integrated: Intel Extreme Graphics controller
AGP video card: AGP 8X

- Audio
Audio controller: ADI 1980

- Network
Network controller: Integrated Intel PRO 10/100 Ethernet

- Power
DC power supply:
Wattage250 W
Heat dissipation 853 BTU (fully-loaded computer without monitor)
Voltage 100 to 120 V at 60 Hz; 200 to 240 V at 50 Hz
Backup battery 3-V CR2032 coin cell

  It is highly recommended to always use the most recent driver version available.

Try to set a system restore point before installing a device driver. This will help if you installed an incorrect or mismatched driver. Problems can arise when your hardware device is too old or not supported any longer.

Related DELL Drivers