JVC KW-DB60ATEND Receiver Firmware 0111 Download

Posted at November 2, 2024 by PCI-DB Team

JVC KW-DB60ATEND Receiver Firmware 0111 Description

Improved functions

- This update improves the reception of DAB tuner.

Preparation:

1. Download the Firmware update file “J12M569_V111.zip” and save it on your desktop. 
2. Unzip it on to your desktop. In the unzipped folder, you will see the file “J13M637.rom”.
3. Copy the file onto a USB flash drive. Do not save into any folder.

Update Procedure:

4. Press the "SOURCE" key and select to "DAB" in the unit.
5. Press and hold "MENU" key almost 2 seconds.
6. TURN the "VOL" knob and select to "TUNER". Press the "VOL" knob.
7. Turn the "VOL" knob and select to firmware version. A firmware version will be appeared on the display as shown below. Press and hold the "VOL" knob almost 2 seconds.
8. Insert the USB flash drive into the car-radio’s USB port
Start updating automatically.
9. It takes almost 20 minutes to update. Do not turn off power during the update.
10. “COMPLETED” message will be displayed when finished.
11. The receiver will be reset automatically.
If “COMPLETE” is still displayed even after 1 minute, please perform following steps.
1. Press the RESET button.
2. Refer to the Step 7 to confirm the firmware version.
12. Remove the USB flash drive.

About A/V Receiver Firmware:

Each Audio-Video Receiver (A/V Receiver) is powered by a firmware version that enables all of its features and allows users to make the most of the device. Updating the firmware can bring various changes that should boost performance, such as improved compatibility with different multimedia file formats.

In order to do so, usually, you must transfer the firmware onto an empty USB storage device, connect the flash drive to the A/V Receiver, and initiate the upgrade process from the device’s setup menu.

However, this task must be carefully performed in a steady power environment, by someone who has completely read and understood all the installation steps or by a power user (recommended) – an update failure can cause your receiver's software to encounter serious malfunctions.

Therefore, if you think that this release can improve your audio-video receiver in any way, get the desired version through the available download button and apply the new firmware; if not, check with our website as often as possible so that you don’t miss the update that might improve your device. 

  It is highly recommended to always use the most recent driver version available.

Try to set a system restore point before installing a device driver. This will help if you installed an incorrect or mismatched driver. Problems can arise when your hardware device is too old or not supported any longer.

Related Others Drivers