Junger D*AP8 FLX Digital Audio Processor Firmware 5.1.0.37710 Download

Posted at December 21, 2024 by PCI-DB Team

Junger D*AP8 FLX Digital Audio Processor Firmware 5.1.0.37710 Description

Changes:

- new feature (Dante) Dante firmware version updated - device is now prepared for AES67 mode operation
- new feature (Audio) Spectral Signature can now be set to manual freeze to stop it from reacting on unwanted audio signals or make use of it as a static equalizer
- new feature (XAP) automatically reconnects after network drop out or power down (XAP firmware update required!)
- new feature (XAP) automatic IP-conflict detection and warning (XAP firmware update required!)
- new feature (Web UI) Dante locked status and AES67 mode shown on Dante interface status page
- new feature (DOLBY) Cat1100 firmware 3.0.0.0 supported
- improved (Web UI) routing matrix scaling permanently enabled
- improved (Web UI) X*AP enable checkboxes greyed out for Remote Hotkeys greater than eight
- fixed (JDSPA) system is no longer trying to fetch parameters from JDSPA if only the bootloader and no firmware is present
- fixed (Web UI) integrated output loudness was not shown in measurement
- fixed (Web UI) time and date are no longer restored from backup file
- fixed (Web UI) issue when setting crosspoints in Google Chrome

Updating the system firmware

1. Start the Web UI of your unit and browse to ‘SYSTEM’ -> ‘Firmware Update’
2. On this page click on ‘Browse…’ in ‘System/Controller’ and locate the ‘basic’ firmware file.
3. Click on ‘start update’ and wait for the update to finish. This may take several minutes and the Web UI may stop responding. This is nothing to worry about. Please be patient. After finishing the update the Web UI will reload.
4. Go back to the firmware page and make sure these two check boxes are checked:
- Update option
- Reboot
5. Now proceed the same way with the final firmware image.

This second step will automatically update all option board firmware. This may even take more time, but in the end all firmware is consistent and up to date within the system.

Please note: Whenever you decide to add an option board to the system, all necessary firmware is already installed. Just install the new hardware and reboot the unit with the two check boxes above set. Please do not use the unit running the basic firmware file!

About Device Firmware:

Applying a newer firmware version than the one already installed on your unit can bring various enhancements, include workarounds for diverse problems encountered by the device, and improve or add newly developed features.

On the other hand, downgrading the firmware version can recover the device’s functionality in the event of a software update either turning up faulty or causing the unit’s overall performance to drop. However, bear in mind that applying an older firmware isn’t recommended and might not always be possible.

When it comes to the update steps, due to the large variety of devices and numerous ways for installing a new firmware, it is recommended that you carefully read and understand the upgrade steps, and consider applying a different firmware only when you have familiarized yourself with the update method.

As the installation process is most of the times quite risky, this step should be taken by users that have the ability to successfully complete the update; regular users may initiate it at their own risk. Moreover, it’s best that this task be performed in a steady power environment such as the one ensured by a UPS unit.

Therefore, if you consider applying this release, hit the download button, take into account all the aforementioned aspects, and update the device’s firmware. Also make sure you constantly check with our website to ensure that you don’t miss a single new release. 

  It is highly recommended to always use the most recent driver version available.

Try to set a system restore point before installing a device driver. This will help if you installed an incorrect or mismatched driver. Problems can arise when your hardware device is too old or not supported any longer.

Related Other Drivers