Buffalo TS5200D NAS Firmware 2.72 Download

Posted at November 2, 2024 by PCI-DB Team

Buffalo TS5200D NAS Firmware 2.72 Description

Bug Fixes:

- Fixed a bug where after the firmware updates to version 2.60 or later, replication will use LAN port 1 if:
- Replication is configured on a TeraStation with firmware version 2.50 or earlier.
- Replication uses both LAN port 1 and 2 (LAN port 2 is prior to use for replication on the TeraStation version 2.50 or earlier).
- Fixed a bug where the settings was not applied if only the LAN port setting of the replication task on the replication target was changed.
- Fixed a bug where data was not resynced if the replication target or source device was changed in the task.
- Fixed a bug where replication uses LAN port 1 instead of LAN port 2 even if the replication task is configured to use LAN port 2 on the TeraStation version 2.60 or later.

[Software description]

- This software will update 5000 and 4000 series TeraStations' firmware to version 2.72. If your unit's firmware is already version 2.72 or later, you don't need this update.

[How to confirm firmware version]

- Select your TeraStation in NAS Navigator2. The firmware version is displayed in the bottom right hand corner of the window.

[Before updating the firmware]

- Do not turn off the TeraStation until the firmware update is complete and the "finished" message is displayed.
- USB drives may not be mounted automatically after updating the firmware. To mount them, unplug and then reconnect them.
- Disconnect iSCSI volumes with the iSCSI initiator before updating the firmware.

[How to update your firmware]

- Connect the TeraStation and a computer to run the updater on the same network subnet. The subnet masks should be the same and the first three numbers of the IP addresses should be the same. The last number of the IP addresses should be different.
- Exit all applications. Also, stop or exit any firewall software.
- Extract the downloaded file and run "TSUpdater.exe". When a TeraStation is detected, an update window will open.
- If multiple TeraStations are connected to the network, select which TeraStation to update.
- Click 'Update' and enter the TeraStation's administrator password.
- Click 'OK'.
- It will take several minutes for the firmware to update. During the update process, the info LED will blink. Don't disconnect or power down the TeraStation until the update is complete.
- When the update is complete, a message will be displayed.

  It is highly recommended to always use the most recent driver version available.

Try to set a system restore point before installing a device driver. This will help if you installed an incorrect or mismatched driver. Problems can arise when your hardware device is too old or not supported any longer.

Related Buffalo Drivers