Intel S2600CW2 Server Board OFU Firmware 1.01.0011 Download

Posted at November 21, 2024 by PCI-DB Team

Intel S2600CW2 Server Board OFU Firmware 1.01.0011 Description

Versions:

- BIOS: 01.01.0011
- ME: 03.00.07.168
- BMC: 01.33.8932
- FRUSDR: 1.11

Changes:

- [R0009] PCIe Bifurcation on CPU2 Riser slot 2 x8x4x4 setting is not correct.
- System sporadically hangs at post code 0x89 (Found during DC power cycle caused by USB SMI)
- Re-timer fails the link margin test with concurrent traffic on SAS bridge board for Haswell CPU
- [24HDD] Suggest add/change some information of SMBIOS Data.
- WCP - NVRAM clear fails when initiated in UEFI Secure Boot mode (System fails to boot after applying/removing NVRAM Clear jumper while in UEFI mode with Secure Boot mode enabled)
- The count of maximum USB mass storage devices cannot match with EPS description.
- BMC WEB GUI does not display memory config with 64GB LRDIMMS.
- After RHEL 7.1(UEFI) OS installation by using 4Kn HDD as system disk, cannot boot to OS.
- Windows RSTe GUI will not start when Grantley system is in UEFI mode.
- Boot into unsign OS the Error Message will shortag
- [HSW]-sysinfo_v13.1.12 some information shown nothing in F2 setup while sysinfo.log has shown
- SMBIOS Type 8 Serial Port type not correct.
- ME version is not correct ,when disabled Quiet Boot function.
- Problems with the static boot order on a WCP system with an Umbrella Canyon RAID controller
- NTB has the performance issue with Grantley BIOS 1.01.0008
- BIOS Memory SPD dump information is not correct for DDR4 caused by offset mismatch with DDR4 spec
- Support for 4X4 PCIe bifurcation support on all X16 PCIe Slot

About General Firmware:

Applying a newer firmware version than the one already installed on your unit can bring various enhancements, include workarounds for diverse problems encountered by the device, and improve or add newly developed features.

On the other hand, downgrading the firmware version can recover the device’s functionality in the event of a software update either turning up faulty or causing the unit’s overall performance to drop. However, bear in mind that applying an older firmware isn’t recommended and might not always be possible.

When it comes to the update steps, due to the large variety of devices and numerous ways for installing a new firmware, it is recommended that you carefully read and understand the upgrade steps, and consider applying a different firmware only when you have familiarized yourself with the update method.

As the installation process is most of the times quite risky, this step should be taken by users that have the ability to successfully complete the update; regular users may initiate it at their own risk. Moreover, it’s best that this task be performed in a steady power environment such as the one ensured by a UPS unit.

Therefore, if you consider applying this release, hit the download button, take into account all the aforementioned aspects, and update the device’s firmware. Also make sure you constantly check with our website to ensure that you don’t miss a single new release.

  It is highly recommended to always use the most recent driver version available.

Try to set a system restore point before installing a device driver. This will help if you installed an incorrect or mismatched driver. Problems can arise when your hardware device is too old or not supported any longer.

Related Intel Drivers