MikroTik RouterOS MIPS-BE Firmware 6.34 RC 9 Download

Posted at November 21, 2024 by PCI-DB Team

MikroTik RouterOS MIPS-BE Firmware 6.34 RC 9 Description

What's new in 6.34rc9:

- ppp - fixed dynamic filter rule adding on some firewall filter configurations;
- vrrp - fixed on-backup script;
- ethernet - fixed link resetting on power-cycle-ping value change;
- pppoe - improved MTU discovery compatibility with other vendors;
- hotspot - fixed login by mac-cookie when roaming among hotspot servers;
- usermanager - fixed usermanager webpage crash;
- ipsec - fixed active SAs flushing;
- bridge - fixed power-cycle-ping for bridge ports (was affecting all bridge);
- pppoe - made MTU discovery more robust;
- hotspot - added option to login user manually from cli;
- pppoe - fixed compliance to RFC4638 (MTU larger than 1488) again;
- hotspot - fixed trial-uptime parsing from CLI to Winbox/Webbox;
- lte - added support for multiple E3372 on the same device;
- modem - added wpd-600n ppp support;
- dhcpv6 client - support DAD and decline;
- dhcpv4 server - fix kernel crash when restoring lease with queue for non-existent server;
- console - fixed incorrect disabled firewall rule matching to "invalid flag";
- ssh - fix key exchange when first kex packet follows;
- dns - fix for situation when dynamic dns servers could disappear;
- sfp - fix 10g ports in 1g mode (introduced in 6.34rc1);
- dhcpv6-client - added DHCPv6-client functionality for current DHCP-PD client;
- CCR1072 - added support for S-RJ01 SFP modules;
- trafficgen - fixed issue that traffic-generator could not be started twice without reboot;
- dhcpv4-client - support /32 address assignment;
- dhcpv6-server - replace delay option with preference option;
- dhcpv6 - implement and enable rapid commit by default.

About Router Firmware:

Before you consider downloading this firmware, go to the system information page of the router and make sure that the currently installed version isn’t either newer or matching this release.

Due to the large variety of router models and different methods for upgrading the device, it is highly recommended that you read and, above all, understand the installation steps before you apply the new firmware, even if you are a power user.

In theory, these steps shouldn’t be much of a hassle for anyone, because manufacturers try to make them as easy as possible, even if they don’t always succeed. Basically, you must upload the new firmware to the router through its administration page and allow it to upgrade.

If you install a new version, you can expect increased security levels, different vulnerability issues to be resolved, improved overall performance and transfer speeds, enhanced compatibility with other devices, added support for newly developed technologies, as well as several other changes.

If you’re looking for certain safety measures, remember that it would be best if you perform the upload using an Ethernet cable rather than a wireless connection, which can be interrupted easily. Also, make sure you don’t power off the router or use its buttons during the installation, if you wish avoid any malfunctions.

If this firmware meets your current needs, get the desired version and apply it to your router unit; if not, check with our website as often as possible so that you don’t miss the update that will improve your device. 

  It is highly recommended to always use the most recent driver version available.

Try to set a system restore point before installing a device driver. This will help if you installed an incorrect or mismatched driver. Problems can arise when your hardware device is too old or not supported any longer.

Related MikroTik Drivers