Creative Sound Blaster Tactic3D Rage Wireless Headset Firmware 1.59 for Mac OS Download

Posted at December 21, 2024 by PCI-DB Team

Creative Sound Blaster Tactic3D Rage Wireless Headset Firmware 1.59 for Mac OS Description

Fixes:

- Support USB audio on PlayStation 4

Instructions to upgrade the Sound Blaster Tactic3D Rage USB Wireless Transmitter:

- Download the file onto your local hard disk.
- Ensure that your Sound Blaster Tactic3D Rage Wireless Transmitter is connected to your computer.
- Ensure that the Sound Blaster Tactic3D Rage Wireless Headset is removed from your computer.
- Double-click the downloaded file to uncompress it.
- Double-click <SBTR_MCFW_WL_US_TX_1_59_140721> inside the uncompressed DMG file.
- Follow the instructions on the screen.
- After the installation of the firmware is completed, unplug and plug in your transmitter and start pairing with the Sound Blaster Tactic3D Rage Wireless headset again.

WARNING:

Please ensure your device is connected during installation. Do not unplug your device until full installation completes. Do not restart your Mac during the firmware upgrade. Do not use a USB hub for installation.

Instructions to upgrade the Sound Blaster Tactic3D Rage Wireless Headset:

- Plug in the Sound Blaster Tactic3D Rage Wireless Headset directly to your computer. Do not connect it to a USB hub.
- Power on the Sound Blaster Tactic3D Rage Wireless Headset.
- Ensure that the Sound Blaster Tactic3D Rage USB Wireless Transmitter is removed from your computer.
- Double-click <SBTR_MCFW_WL_US_RX_1_58_A_121101> inside the uncompressed DMG file.
- To complete the installation, follow the instructions on the screen.
- After installing the firmware, re-pair your headset and the USB wireless transmitter.

Manual Pairing:

- Press and hold the Microphone Mute button on the headset for 3 seconds. The connect LED will begin to flash rapidly.
- Press and hold the Connect button on the USB wireless transmitter for 3 seconds. The Connect LED on the transmitter will begin to flash rapidly.
- When the headset and the transmitter are paired, the Connect LED on both devices will stop flashing and stabilize.

  It is highly recommended to always use the most recent driver version available.

Try to set a system restore point before installing a device driver. This will help if you installed an incorrect or mismatched driver. Problems can arise when your hardware device is too old or not supported any longer.

Related CREATIVE Drivers