Nikon COOLPIX P500 Firmware 1.1 for Mac OS Download

Posted at April 29, 2024 by PCI-DB Team

Install Driver Automatically

Device Name	Nikon COOLPIX P500 Firmware 1.1 for Mac OS
Category	Firmware
Manufacturer	Nikon
File Size	6 MB
Supported OS	Mac

Nikon COOLPIX P500 Firmware 1.1 for Mac OS Description

Fixes:
- When a fully charged battery was inserted in the camera, the camera used and then turned off and left for a while, in some rare cases the battery was exhausted and the camera could not be turned on again. This issue has been resolved.
- In some rare cases, the monitor failed to properly display images with continuous shooting at a setting of Continuous L. This issue has been resolved.
- When the following SD memory cards were inserted into the camera and the camera turned on, the “This card cannot be used.” message was sometimes displayed. This issue has been resolved.
SanDisk Extreme Pro SDHC UHS-I (32 GB, 16 GB, 8 GB)
SanDisk Extreme SDHC UHS-I (32 GB, 16 GB, 8 GB, 4 GB)
SanDisk Extreme Pro SDHC UHS-I (32 GB, 16 GB, 8 GB)
SanDisk Extreme SDHC UHS-I (32 GB, 16 GB, 8 GB, 4 GB)
- An issue that caused settings registered using the Save user settings option to be reset when camera settings were reset using the Reset all option in the setup menu with [U] (user setting) shooting mode enabled has been resolved.

  It is highly recommended to always use the most recent driver version available.

Try to set a system restore point before installing a device driver. This will help if you installed an incorrect or mismatched driver. Problems can arise when your hardware device is too old or not supported any longer.

Related Nikon Drivers