D-Link DCS-5020L rev. A IP Camera Firmware 1.10.02 Download

Posted at December 22, 2024 by PCI-DB Team

D-Link DCS-5020L rev. A IP Camera Firmware 1.10.02 Description

New Features:

1. New mydlink agent 2.0.19-b07
2. Add direct mode (v0.5) support

Problems Fixed:

1. Fixed HTTPS issue that caused Pan/Tilt and Day/Night control to fail in Portal and apps.

Upgrading Instructions:

Follow the steps below to upgrade the firmware:
1. Download the latest firmware file. The file is in .bin file format.
2. Log-in camera web UI and enter setup/Maintenance/Firmware upgrade 3. Click Browse… and specify the firmware file.
3. Click Upgrade. The camera starts to upgrade and will reboot automatically when the upgrade completes.

How to update your camera firmware:

- Check your connections. Make sure your device is connected to your router with an Ethernet cable for the upgrade process. Do not use a wireless connection when upgrading the firmware.
- Also, make sure you use a computer connected to the same router as your device. Do not perform this process through a remote connection to your device over the Internet.
- Download the firmware to your PC and then unzip it if necessary.
- Open your device’s web interface. To do this run your device’s Setup Wizard and write down the IP Address for your device then write that IP Address into your web browser and login as admin with your password for it.
- Go to MAINTENANCE > Firmware Upgrade to go to the Firmware Upgrade page. Click “Browse” and then select the firmware file you saved and unzipped on your computer in the previous steps.
- After selecting the firmware file, click Upload to start the upgrade process.
- The upgrade process will begin, and will take about 2-3 minutes to complete. Do not start or use other applications while upgrading your device’s firmware, and do not hit Stop, Back, or Reload in your web browser during the upgrade process.
- Once the upgrade process is complete, click on the Firmware Upgrade link on the left to return to the Firmware Upgrade page.
- Verify that the Current Firmware Version matches the version of the firmware you uploaded. The upgrade process is complete, and you can close your web browser.

About Surveillance/Network Camera Software:

Applying the appropriate software for your network camera helps computers properly connect with the device, and adds support for various surveillance features that the camera benefits from (such as monitoring specific areas).

If you're considering a software upgrade, you should know that this process might improve the unit's overall performance and stability, add support for new features (or enhance existing ones), or include fixes for various issues. However, bear in mind that not all software updates bring significant changes.

As for the installation method, the steps vary depending on the type of software that you are about to apply; so, make sure you carefully read and understand the installation steps so that you don't end up with a broken device.

If you're thinking about applying this software version, hit the download button and update your camera once you have familiarized yourself with the installation method. In addition to that, don't forget to check with our website as often as possible so that you don't miss a single new release.

  It is highly recommended to always use the most recent driver version available.

Try to set a system restore point before installing a device driver. This will help if you installed an incorrect or mismatched driver. Problems can arise when your hardware device is too old or not supported any longer.

Related D-Link Drivers