Posted at November 2, 2024 by PCI-DB Team
Install Driver AutomaticallyDevice Name | Mellanox MSX6015T rev.Ax Switch Firmware 9.3.6000 |
---|---|
Category | Router Switch Access Point |
Manufacturer | Mellanox |
File Size | 577 KB |
Supported OS | OS Independent |
- Added support for bandwidth monitoring according to Performance histogram in Vendor Specific MAD spec
- Cannot enable 40GbE on backplane ports
- Reset cannot be performed during I2C operation
- The SampleCounter mechanism is not supported.
- Resetting the counters of port receive packets and port receive unicast packets using “Performance class MAD” or the VL15 received packets and data counters using Mellanox Vendor Specific MAD resets all of the above counters.
- FDR link may raise as FDR10 when plugged in near an FDR10 cable.
- Link width negotiation is not supported.
- Link up negotiation may take up to 70 seconds.
- DDR link may rise with errors or at SDR speed when connecting to ConnectX®-3 version
- 2.30.3000 or earlier, Connect-IB™ version 10.10.1000 or earlier, or previous releases of SwitchX®.
- QDR capabilities at the INI must be enabled when working in FDR mode.
- Downgrading to firmware version 9.2.0000 requires power cycling the switch for the firmware to load.
- Loopback modules are not supported and do not link up.
Given the large variety of models and different methods for upgrading the switch, if you wish to apply this package, we recommend that you read and understand the installation steps before you install a new firmware, even if you are a power user.
Usually the update procedure isn’t much of a hassle as manufacturers try to make it as simple as possible; however, there are cases that are exceptions to this rule. First off, go to the system information page of the switch to check that the currently installed version isn’t either newer or matching this release.
Applying a new firmware can decrease the security vulnerabilities, enhance overall performance and compatibility, improve various power management functions, resolve different errors, and add support for newly developed technologies and protocols.
It is recommended that you perform this step in a steady power environment such as the one ensured by a UPS unit, and that you don’t interrupt the upgrade in any way, because this might cause the switch to malfunction.
That being said, click the download button, get and apply the new version, and check back with our website constantly to stay up to speed with the latest releases.
It is highly recommended to always use the most recent driver version available.
Try to set a system restore point before installing a device driver. This will help if you installed an incorrect or mismatched driver. Problems can arise when your hardware device is too old or not supported any longer.
Device Type: Network Card File Size: 42.2 MB Windows 2008
Install DriverDevice Type: Network Card File Size: 42.2 MB Windows 2008
Install DriverDevice Type: Network Card File Size: 42.2 MB Windows Server 2012
Install DriverDevice Type: Network Card File Size: 42.1 MB
Install DriverDevice Type: Network Card File Size: 42.3 MB Windows Server 2012
Install DriverDevice Type: Network Card File Size: 42.2 MB Windows Server 2012
Install DriverDevice Type: Network Card File Size: 42.2 MB Windows 7 ,Windows 7 64 bit
Install DriverDevice Type: Network Card File Size: 42.3 MB Windows 8.1 ,Windows 8.1 64 bit
Install DriverDevice Type: Network Card File Size: 42.3 MB Windows Server 2012
Install DriverDevice Type: Network Card File Size: 42.1 MB
Install DriverFind Missing Drivers
Recent Devices
Recent Drivers
© 2024 PCI-DB.com - PCI Database Replacement. All rights reserved.