MikroTik RouterOS SMIPS Firmware 6.38 RC 24 Download

Posted at December 22, 2024 by PCI-DB Team

MikroTik RouterOS SMIPS Firmware 6.38 RC 24 Description

Changes:

- ipsec - added IKEv1 xauth user authentication with RADIUS "/ip ipsec user settings set radius=yes" (cli only);
- ipsec - added IKEv2 experimental support with pre-shared-key and rsa-signature authentication methods (cli only);
- ipsec - added support unique policy generation which will allow multiple peers behind the same NAT (cli only);
- tr069-client - initial implementation (as separate package);
- arms - improved watchdog reliability;
- bonding - added "forced-mac-address" option (cli only);
- bonding - fixed 802.3ad load balancing over routed VLANs with fastpath enabled;
- bonding - fixed mac address selection after upgrade;
- bridge - fixed rare crash on bridge port removal;
- certificates - fixed trust chain update on local certificate revocation in programs using ssl;
- crs - added comment ability in more switch menus;
- crs - fixed port mirroring halt after L2MTU change;
- fastpath - improved connection tracking timeout updates;
- firewall - fixed "connection-state" value disappearance in rules that were created before v6.22;
- firewall - improved "time" option (ranges like 22h-10h now are acceptable);
- ipsec - added ph2 accounting for each policy "/ip ipsec policy ph2-count" (cli only);
- ipsec - non passive peers will also establish SAs from policy without waiting for the first packet;
- log - fixed "System rebooted because of kernel failure" message to show after 1st crash reboot;
- mmips - fixed traffic accounting in "/interface" menu;
- mmips - improved watchdog reliability;
- profiler - added ability to monitor cpu usage per core;
- queue - fixed rare crash on statistic gathering in "/queue tree";
- queue - improved "time" option (ranges like 22h-10h are now usable);
- wireless - added CRL checking for eap-tls;
- ipv6 - increased default max-neighbor-entries value to 8192, same as ipv4;
- ssl - fixed potential memory leak ( when using dude for example);

About Router Firmware:

Before you consider downloading this firmware, go to the system information page of the router and make sure that the currently installed version isn’t either newer or matching this release.

Due to the large variety of router models and different methods for upgrading the device, it is highly recommended that you read and, above all, understand the installation steps before you apply the new firmware, even if you are a power user.

In theory, these steps shouldn’t be much of a hassle for anyone, because manufacturers try to make them as easy as possible, even if they don’t always succeed. Basically, you must upload the new firmware to the router through its administration page and allow it to upgrade.

If you install a new version, you can expect increased security levels, different vulnerability issues to be resolved, improved overall performance and transfer speeds, enhanced compatibility with other devices, added support for newly developed technologies, as well as several other changes.

If you’re looking for certain safety measures, remember that it would be best if you perform the upload using an Ethernet cable rather than a wireless connection, which can be interrupted easily. Also, make sure you don’t power off the router or use its buttons during the installation, if you wish avoid any malfunctions.

If this firmware meets your current needs, get the desired version and apply it to your router unit; if not, check with our website as often as possible so that you don’t miss the update that will improve your device.

  It is highly recommended to always use the most recent driver version available.

Try to set a system restore point before installing a device driver. This will help if you installed an incorrect or mismatched driver. Problems can arise when your hardware device is too old or not supported any longer.

Related MikroTik Drivers