Gigabyte GA-Z97X-Gaming GT (rev. 1.0) Marvell SATA Controller Driver 1.0.0.1061 Download

Posted at December 31, 2024 by PCI-DB Team

Gigabyte GA-Z97X-Gaming GT (rev. 1.0) Marvell SATA Controller Driver 1.0.0.1061 Description

Specifications:

CPU:
Support for Intel Core i7 processors/Intel Core i5 processors/ Intel Core i3 processors/Intel Pentium processors/Intel Celeron processors in the LGA1150 package
- L3 cache varies with CPU

Chipset:

- Intel Z97 Express Chipset

Memory:

- 4 x DDR3 DIMM sockets supporting up to 32 GB of system memory
- Dual channel memory architecture
- Support for 3200(O.C.) / 3100(O.C.) / 3000(O.C.) / 2933(O.C.) / 2800(O.C.) / 2666(O.C.) / 2600(O.C.) / 2500(O.C.) / 2400(O.C.) / 2200(O.C.) / 2133(O.C.) / 2000(O.C.) / 1866(O.C.) / 1800(O.C.) / 1600 / 1333 MHz memory modules
- Support for non-ECC memory modules
- Support for Extreme Memory Profile (XMP) memory modules

Onboard Graphics:

- Integrated Graphics Processor
- 1 x D-Sub port, supporting a maximum resolution of 1920x1200 @ 60Hz
- 1 x DVI-D port, supporting a maximum resolution of 1920x1200 @ 60Hz
- 1 x HDMI port, supporting a maximum resolution of 4096x2160 @ 24Hz or 2560x1600 @ 60Hz
- 1 x DisplayPort, supporting a maximum resolution of 4096x2160 @ 24Hz or 3840x2160 @ 60Hz
- Support for up to 3 displays at the same time
- Maximum shared memory of 1 GB

Audio:

- Realtek ALC1150 codec
- TI Burr Brown OPA2134 operational amplifier
- Support for Sound Blaster X-Fi MB3
- High Definition Audio
- 2/4/5.1/7.1-channel
- Support for S/PDIF Out

LAN:

- Qualcomm Atheros Killer E2201 LAN chip (10/100/1000 Mbit)

Expansion Slots:

- 2 x PCI Express x16 slots, running at x16 (PCIEX16_1~2)
- 2 x PCI Express x16 slots, running at x8 (PCIEX8_1~2)
- 3 x PCI Express x1 slots

Multi-Graphics Technology:

- Support for 4-Way/3-Way/2-Way AMD CrossFire/NVIDIA SLI technology

Storage Interface:

- 1 x SATA Express connector
- 6 x SATA 6Gb/s connectors (SATA3 0~5)
- Support for RAID 0, RAID 1, RAID 5, and RAID 10
- Marvell 88SE9172 chip
- 4 x SATA 6Gb/s connectors (GSATA3 6~7)
- Support for RAID 0 and RAID 1

USB:

- 4 x USB 3.0/2.0 ports (2 ports on the back panel, 2 ports available through the internal USB header)
- 8 x USB 2.0/1.1 ports (2 ports on the back panel, 6 ports available through the internal USB header)
- Chipset + Renesas uPD720210 USB 3.0 Hub:
- 4 x USB 3.0/2.0 ports on the back panel

Internal I/O Connectors:

- 1 x 24-pin ATX main power connector
- 1 x 8-pin ATX 12V power connector
- 1 x PCIe power connector
- 1 x SATA Express connector
- 8 x SATA 6Gb/s connectors
- 1 x CPU fan header
- 1 x water cooling fan header (CPU_OPT)
- 5 x system fan headers
- 1 x front panel header
- 1 x front panel audio header
- 1 x S/PDIF Out header
- 1 x USB 3.0/2.0 header
- 3 x USB 2.0/1.1 headers
- 1 x serial port header
- 1 x Clear CMOS jumper
- 1 x power button
- 1 x reset button
- 1 x Clear CMOS button
- 1 x audio gain control switch
- 8 x onboard voltage measurement points
- 2 x BIOS switches

Back Panel Connectors:

- 1 x PS/2 keyboard/mouse port
- 1 x D-Sub port
- 1 x DVI-D port
- 1 x optical S/PDIF Out connector
- 1 x HDMI port
- 1 x DisplayPort
- 6 x USB 3.0/2.0 ports
- 2 x USB 2.0/1.1 ports
- 1 x RJ-45 port
- 6 x audio jacks (Center/Subwoofer Speaker Out, Rear Speaker Out, Side Speaker Out, Line In, Line Out, Mic In)

I/O Controller:

- iTE I/O Controller Chip

H/W Monitoring:

- System voltage detection
- CPU/System/Chipset temperature detection
- CPU/CPU OPT/System fan speed detection
- CPU/System overheating warning
- CPU/CPU OPT/System fan fail warning
- CPU/CPU OPT/System fan speed control

Form Factor:

- ATX Form Factor; 30.5cm x 24.4cm

  It is highly recommended to always use the most recent driver version available.

Try to set a system restore point before installing a device driver. This will help if you installed an incorrect or mismatched driver. Problems can arise when your hardware device is too old or not supported any longer.

Related Marvell Drivers