Corsair Force GT 90GB SSD Firmware 1.3.3 Download

Posted at November 21, 2024 by PCI-DB Team

Corsair Force GT 90GB SSD Firmware 1.3.3 Description

IMPORTANT NOTES BEFORE BEGINNING YOUR UPDATE

If you are stable and do not have issues, we suggest that you do not flash your firmware. This update is intended to not be destructive. However, we strongly urge that you back up any important data before beginning this procedure. Be sure to download the correct update file for your drive. Many complaints we have seen were the result of downloading the wrong file for your drive.

This update has been validated for use with Windows 7. It has not been validated with Windows Vista and Windows XP however it may work with these OS's. Users are encouraged to update the drives with Windows 7 when possible.

This update tool is intended to be run with the drive controller in AHCI mode. If your drive controller is not AHCI enabled and your update fails, you will need to change it to AHCI mode and also enable AHCI in your OS registry. Here is page with a guide for ENABLING AHCI.

If you have issues updating using the Microsoft AHCI driver, you may need to update using the latest driver from your drive controller manufacturer. The reverse is also true. If you have issues updating using the latest drivers from your controller manufacturer, we suggest you try the latest MS AHCI driver.

Our latest testing is only with Intel and AMD drive controllers. The update may not work with 3rd party drive controllers. The update will not work on a controller that is in RAID mode. This applies to SATA2 and SATA3 controllers.

DO NOT at any time power off your system during this procedure. This may “brick” your drive. After your update if you still have issues, we strongly recommend the following steps:
- Complete clearing of the BIOS. This is a good idea after any firmware flash of any device
- Secure erase the SSD. For some users, cloning of the drive works, for others it does not
This may be dependent upon the cloning tool used
- A clean installation of the OS if you experience instability after a BIOS clearing and secure erase

UPDATE YOUR MOTHERBOARD BIOS. As always for users with issues, we recommend that you update your motherboard/notebook to the most recent BIOS before attempting to flash your firmware. This may or may not resolve your issue but it is an excellent first step. Quite a few boards/notebooks have been given SSD specific updates over the past few months.

We have seen no issues updating directly from 1.2 to 1.3.3. Ignore any terms in the firmware file name relating to Micron, Intel, etc. This has no bearing on the upgrade. You need only match the SIGNATURE as noted in the .PDF file.

Fixes:

- Fixed a rare condition when waking from slumber mode that could cause the drive to hang. This can cause a BSoD if the drive is the primary storage boot device.
- Fixed a rarely occurring issue during S3/S4 cycling to handle marginal flash timing. This can cause a BSoD if the drive is the primary storage boot device.
- Fixed an issue during a firmware update where APM would be marked disabled in identify.

  It is highly recommended to always use the most recent driver version available.

Try to set a system restore point before installing a device driver. This will help if you installed an incorrect or mismatched driver. Problems can arise when your hardware device is too old or not supported any longer.

Related Corsair Drivers